Search results
Results From The WOW.Com Content Network
Some areas of failure on this transmission include leaks in the oil filling tube by removing the cap incorrectly, damage to plastic internals due to fluid over-temperature conditions, leaks in the transmission oil cooler, internal fluid pressure leaks from torn piston diaphragms, worn piston bores for solenoids in aluminum valve body, and the resulting worn clutches and bands.
At stall, the torque converter can produce maximum torque multiplication if sufficient input power is applied (the resulting multiplication is called the stall ratio). The stall phase actually lasts for a brief period when the load (e.g., vehicle) initially starts to move, as there will be a very large difference between pump and turbine speed.
A torque tube system is a power transmission and braking technology that involves a stationary housing around the drive shaft, often used in automobiles with a front engine and rear drive. The torque tube consists of a large diameter stationary housing between the transmission and rear end that fully encloses a rotating tubular steel or small ...
An automotive drive shaft can typically last about 120,000 kilometres. However, if the vehicle experiencing any of the signs below, drivers should get it checked as soon as possible. [11] Clicking or squeaking noise: Driver can either hear a clicking, squeaking, or grinding noises coming from underneath the vehicle when driving.
It linked the front and rear differentials for quiet and smooth transfer of power to the axle with the greatest traction, on wet or dry pavement. [ 4 ] Viscous couplings are used as the center differential in cars such as the Toyota Celica GT-Four , and also as a limited slip differential (LSD) in rear axles.
The number of main bearings is primarily determined by the overall load factor and maximum engine speed. [1] Increasing the number of bearings in an engine will generally increase the size and cost of the engine, but also reduces bending stress and deflection caused by the distance from the crank pins to the nearest bearings.
The amount of limiting torque provided by these mechanisms varies by design. A limited-slip differential has a more complex torque-split and should be considered in the case when the outputs are spinning the same speed and when spinning at different speeds. The torque difference between the two axles is called Trq d . [8]
DC machines may have leakage current from the armature windings that energizes the shaft. Currents due to shaft voltage causes deterioration of motor bearings, but can be prevented with a grounding brush on the shaft, grounding of the motor frame, insulation of the bearing supports, or shielding.