Ads
related to: find modem on computerfiber.att.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
Commercial modems largely did not become available until the late 1950s, when the rapid development of computer technology created demand for a method of connecting computers together over long distances, resulting in the Bell Company and then other businesses producing an increasing number of computer modems for use over both switched and ...
The modem uses the Data Carrier Detect (DCD) pin to signal whether it's connected to a host. The computer can generally just read the DCD pin at any time and always know if the modem is in command or data mode. DCD high means data mode, and low means command mode. DCD is a signal sent from the modem to the computer.
Reboot your modem/router - Sometimes the old "turn it off and on again" approach actually does work! Just wait about five minutes before turning it back on to make sure everything was reset. Just wait about five minutes before turning it back on to make sure everything was reset.
The modem connects to a single computer or router, through an Ethernet port, USB port, or is installed in a computer PCI slot. The more common DSL router is a standalone device that combines the function of a DSL modem and a router, and can connect multiple computers through multiple Ethernet ports or an integral wireless access point.
Unplug all phone devices in your home - Unplug all phone devices in your home, then reconnect just the modem. Try to connect online, and if it works, plug in each device one at a time until you find the one causing the problem. Restart your computer and modem - Sometimes the old "turn it off and on again" approach actually does work! Just wait ...
The other end of the cord must be plugged securely into the modem jack labeled Line, Telco, or Wall. Note : For best results, the phone cord should go directly to the wall jack. Remove any splitters, phone line surge protectors, fax or answering machines, or other devices as they may affect your modem’s ability to connect.
Data Carrier Detect (DCD) or Carrier Detect (CD) is a control signal present inside an RS-232 serial communications cable that goes between a computer and another device, such as a modem. This signal is a simple "high/low" status bit that is sent from a data communications equipment (DCE) to a data terminal equipment (DTE), i.e., from the modem ...
An example handshake of a dial-up modem. Modern dial-up modems typically have a maximum theoretical transfer speed of 56 kbit/s (using the V.90 or V.92 protocol), although in most cases, 40–50 kbit/s is the norm. Factors such as phone line noise as well as the quality of the modem itself play a large part in determining connection speeds.