Search results
Results From The WOW.Com Content Network
Dynamic load testing (or dynamic loading) is a method to assess a pile's bearing capacity by applying a dynamic load to the pile head (a falling mass) while recording acceleration and strain on the pile head. Dynamic load testing is a high strain dynamic test which can be applied after pile installation for concrete piles. For steel or timber ...
The race is brought into contact with a square steel test block under a constant load. The contact area is flooded with the lubricant or grease being tested. The Timken OK Load is the highest standard load at which the spinning bearing race produces no scouring mark on the test block, but only a uniform wear scar. [1]
Once the machine is started it begins to apply an increasing load on specimen. Throughout the tests the control system and its associated software record the load and extension or compression of the specimen. Machines range from very small table top systems to ones with over 53 MN (12 million lbf) capacity. [3] [4]
Bearing rings and rolling elements can be made of a number of different materials, but the most common is "chrome steel", (high carbon chromium) a material with approximately 1.5% chrome content. Such "chrome steel" has been standardized by a number of authorities, and there are therefore a number of similar materials, such as: AISI 52100 (USA ...
It is also used in testing a specimen, for a process where the crosshead moves to load the specimen to a specified value before a test starts. Data is not captured during the preload segment. When tensile specimens are initially placed into testing grips, they can be subjected to small compressive forces. These forces can cause specimens to ...
Radial run-out is caused by the tool being translated off the machine axis, still parallel. Radial run-out will measure the same all along the machine axis. Axial run-out is caused by the tool or component being at an angle to the axis. Axial run-out causes the tip of the tool or shaft to rotate off-centre relative to the base.
In mechanical engineering, backlash, sometimes called lash, play, or slop, is a clearance or lost motion in a mechanism caused by gaps between the parts. It can be defined as "the maximum distance or angle through which any part of a mechanical system may be moved in one direction without applying appreciable force or motion to the next part in mechanical sequence."
Kentledge load testing in Haikou, Hainan, China. Static load testing is an in situ type of load testing used in geotechnical investigation to determine the bearing capacity of deep foundations prior to the construction of a building. It differs from the statnamic load test and dynamic load testing in that the pressure applied to the pile is slower.