Search results
Results From The WOW.Com Content Network
Prior to the STC rating, the sound isolation performance of a partition was measured and reported as the average transmission loss of over the frequency range 128 to 4096 Hz or 256 to 1021 Hz. [ 8 ] [ 9 ] This method is valuable at comparing homogeneous partitions that follow the mass law, but can be misleading when comparing complex or multi ...
According to Stevens' definition, a loudness of 1 sone is equivalent to 40 phons (a 1 kHz tone at 40 dB SPL). [1] The phons scale aligns with dB, not with loudness, so the sone and phon scales are not proportional. Rather, the loudness in sones is, at least very nearly, a power law function of the signal intensity, with an exponent of 0.3.
IEC 60287 Electric cables – Calculation of the current rating IEC 60294 Measurement of the dimensions of a cylindrical component with axial terminations IEC 60296 Fluids for electrotechnical applications – Unused mineral insulating oils for transformers and switchgear
The utilization categories category for low-voltage switchgear defines the characteristic operating conditions for switchgear such as contactors, circuit-breakers, circuit-breaker-fuse units, contactor relays, etc. These devices are dimensioned for different electrical loads and for different operating conditions.
The standard includes preferred current ratings and wire gauges for both International (deemed Series I) and North American (deemed Series II) applications. Series I preferred current ratings (in amps) are: 16, 32, 63, 125, 250, 400, 630 and 800, with wire gauges specified as mm 2.
IEC 61140: Protection against electric shock — Common aspects for installation and equipment. International Electrotechnical Commission. 2001. (formerly: IEC 536-2: Classification of electrical and electronic equipment with regard to protection against electric shock, 1992) BS 2754 : 1976 (1999): Memorandum.
A circuit diagram (or: wiring diagram, electrical diagram, elementary diagram, electronic schematic) is a graphical representation of an electrical circuit. A pictorial circuit diagram uses simple images of components, while a schematic diagram shows the components and interconnections of the circuit using standardized symbolic representations ...
Dynamic (electrical overhead-)line rating is a great opportunity for transmission line operators (any voltage from 15 kV to 735 kV and over). It has been studied for more than 20 years inside CIGRE and IEEE working groups.