Ads
related to: connectors for 10mm cable tv ends
Search results
Results From The WOW.Com Content Network
Generally use coaxial cable types such as RG-6 and RG-59 (except for twin-lead). Belling-Lee/IEC 169-2 connector TV aerial plug (a.k.a. antenna plug) Television antenna connection for most video devices outside North America. Used by early home computers and game consoles to connect them to TVs because of the lack of any other connector.
The F connector (also F-type connector) is a coaxial RF connector commonly used for "over the air" terrestrial television, cable television and universally for satellite television and cable modems, usually with RG-6/U cable or with RG-59/U cable. The F connector was invented by Eric E. Winston in the early 1950s while working for Jerrold ...
The 4.3-10 connector (sometimes referred to as 4.3/10) is a 50 Ω multi-purpose RF connector used to connect coaxial cables with other cables or RF devices, such as transmitters or antennas. The IEC standard 61169-54 specifies an inner diameter of the outer conductor is 10 mm and the outer diameter of the inner conductor is 4.3 mm.
Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [9] using a special power or manual tool. [10] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used ...
A standard rack-mount headend. Once a television signal is received, it must be processed. For digital satellite TV signals, a dedicated commercial satellite receiver is needed for each channel that is to be distributed by the cable system; these are usually rack-mountable receivers that are designed to take up less space than consumer receivers.
The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate: