Search results
Results From The WOW.Com Content Network
An idealized and extreme smiley face curve shown using a 29-band graphic equalizer. A smiley face curve or mid scoop [1] in audio signal processing is a target frequency response curve characterized by boosted low and high frequencies coupled with reduced midrange frequency power.
An exciter (also called a harmonic exciter or aural exciter) is an audio signal processing technique used to enhance a signal by dynamic equalization, phase manipulation, harmonic synthesis of (usually) high frequency signals, and through the addition of subtle harmonic distortion. Dynamic equalization involves variation of the equalizer ...
HF's position in the electromagnetic spectrum.. High frequency (HF) is the ITU designation [1] [2] for the band of radio waves with frequency between 3 and 30 megahertz (MHz). It is also known as the decameter band or decameter wave as its wavelengths range from one to ten decameters (ten to one hundred meters).
For example, in Europe, for many years recordings required playback with a bass turnover setting of 250 to 300 Hz and a treble rolloff at 10,000 Hz ranging from 0 to −5 dB, or more. In the United States, practices varied and a tendency arose to use higher bass turnover frequencies, such as 500 Hz, as well as a greater treble rolloff such as ...
High-frequency roll-off that is not fully compensated in the replay channel may be offset by pre-emphasis during recording. [29] Lower replay time constants decrease the apparent level of hiss (by 4 dB when stepping down from 120 to 70 μs ), but also decrease apparent high-frequency saturation level, so the choice of time constants was a ...
Treble describes tones of high frequency or high pitch, ranging from 6 kHz to 20 kHz, [1] comprising the higher end of the human hearing range. In music, this corresponds to high notes. The treble clef is often used to notate such notes. [2] Treble sound is the counterpart to bass sound.
Low-pass filters are used in audio crossovers to remove high-frequency content from signals being sent to a low-frequency subwoofer system. High-pass A high-pass filter does the opposite, passing high frequencies above the cutoff frequency, and progressively attenuating frequencies below the cutoff frequency. [2] A high-pass filter can be used ...
System non-linearities (present to varying degrees in all audio reproduction electronics, loudspeakers, etc.) are known to produce lower-frequency intermodulation products when the system is stimulated with high frequency signals. It is suggested that this mechanism could produce signals in the audible range that allow listeners to distinguish ...