When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Annular cutter - Wikipedia

   en.wikipedia.org/wiki/Annular_cutter

   An annular cutter (also called a core drill, core cutter, broach cutter, trepanning drill, hole saw, or cup-type cutter) is a form of core drill used to create holes in metal. An annular cutter, named after the annulus shape , cuts only a groove at the periphery of the hole and leaves a solid core or slug at the center.

3. Milling cutter - Wikipedia

   en.wikipedia.org/wiki/Milling_cutter

   Milling cutters are cutting tools typically used in milling machines or machining centres to perform milling operations (and occasionally in other machine tools).They remove material by their movement within the machine (e.g., a ball nose mill) or directly from the cutter's shape (e.g., a form tool such as a hobbing cutter).

4. End mill - Wikipedia

   en.wikipedia.org/wiki/End_mill

   Contouring/Profiling: this is a process used to mill different surfaces such as flat or irregular ones. This type of process can be done during the roughing or finishing phase of the overall operation. [4] Facing: is an operation used to face the part down to specified dimension. Facing can be done using end mills or a special face mill. [5] [6 ...

5. Hole saw - Wikipedia

   en.wikipedia.org/wiki/Hole_saw

   Tungsten carbide hole saw with arbor A 52 mm (2.0 in) hole saw with pilot bit A 115 mm (4.5 in) diamond hole saw. A hole saw (also styled holesaw), also known as a hole cutter, [1] is a saw blade of annular (ring) shape, whose annular kerf creates a hole in the workpiece without having to cut up the core material.

6. Cutting tool (machining) - Wikipedia

   en.wikipedia.org/wiki/Cutting_tool_(machining)

   3 angles: clearance angle, wedge angle, rake (chipping) angle; Δr; length and orientation of the bevel; Cutting edge profile with parameters. One of the most important cutting edge parameters is the K factor. It specifies the form of the cutting edge. 1 means a symmetric cutting edge. If the value is smaller than 1 the form is called a waterfall.

7. Speeds and feeds - Wikipedia

   en.wikipedia.org/wiki/Speeds_and_feeds

   Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.