Ad
related to: where to mount trx anchor cable kit system 3
Search results
Results From The WOW.Com Content Network
Triaxial cable, often referred to as triax for short, is a type of electrical cable similar to coaxial cable, but with the addition of an extra layer of insulation and a second conducting sheath. Triax provides greater bandwidth and rejection of interference than coax, but is more expensive.
The device is anchored to the seabed by a "UMACK" pile, developed within the Universal Mooring, Anchor & Connectivity Kit Demonstration project. [6] It uses a pneumatic pre-tensioning system to reduce the mass of the oscillating body, thus increasing its natural frequency. The natural state of the device is therefore detuned to the period of ...
A A-grade Also aid climbing grade. The technical difficulty grading system for aid climbing (both for "original" and an adapted version for "new wave"), which goes: A0, A1, A2, A3, A4, A5 and up to A6 (for "new wave"). See C-grade. Abalakov thread Abalakov thread Also V-thread. A type of anchor used in abseiling especially in winter and in ice climbing. ABD Also assisted braking device. A term ...
Termination tower (overhead line to underground cable) Future termination tower of a 110 kV-line while joins are installed. A special kind of a dead-end tower is a termination pylon, also called a terminal tower. It is used when the overhead power line terminates, and is connected to substation equipment, or transitions to underground cable.
A load-sharing (or load-distributing) anchor is a system consisting of two or more individual anchors which join together at a main anchor point to form an anchoring system. This configuration is a way to introduce redundancy and increase strength, typically for a belay anchor.
For premium support please call: 800-290-4726 more ways to reach us
The anchor must be adequate to resist the maximum tensile load of the guy wires; both the dead load of the tension of the wire and the maximum possible live load due to wind. Since the guy wire exerts its force at an angle, the anchor has both vertical and lateral (horizontal) forces on it.
Bitts aboard wooden sailing ships (sometime called cable-bitts) were large vertical timbers mortised into the keel and used as the anchor cable attachment point. [2] Bitts are carefully manufactured and maintained to avoid any sharp edges that might chafe and weaken the mooring lines. [3]