When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Concrete sealer - Wikipedia

   en.wikipedia.org/wiki/Concrete_sealer

   In past decades attempts to protect concrete have included sealers ranging from wax to linseed oil. Today, high quality concrete sealers can block up to 99% of surface moisture. There are two main sealer categories: topical sealers (coatings) and penetrating sealers (reactive).

3. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   Silicones also exhibit good chemical resistance and high-temperature resistance (205 °C, 400 °F and higher). For this reason, silicone molds are suitable for casting low-melt metals and alloys (e.g. zinc, tin, pewter, and Wood's metal). RTV silicone rubbers are, however, generally expensive – especially platinum-cure.

4. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Two-part silicone systems are used as rubber molds to cast resins, foams, rubber, and low-temperature alloys. A silicone mold generally requires little or no mold-release or surface preparation, as most materials do not adhere to silicone. For experimental uses, ordinary one-part silicone can be used to make molds or to mold into shapes.

5. Silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Silicone_rubber

   A variety of fillers can be used in silicone rubber, although most are non-reinforcing and lower the tensile strength. Silicone rubber is available in a range of hardness levels, expressed as Shore A or IRHD between 10 and 100, the higher number being the harder compound. It is also available in virtually any colour, and can be colour matched.

6. Bulk moulding compound - Wikipedia

   en.wikipedia.org/wiki/Bulk_moulding_compound

   The mixing is done at room temperature and stored at low temperatures to slow down curing prior to molding. The concentration of the mixture can vary depending on application, but is typically 30% glass fibers, 25% filler, and 45% resin, styrene, and initiator. [2] The material is provided in bulk or in logs approximately 4" in diameter.

7. Filler (materials) - Wikipedia

   en.wikipedia.org/wiki/Filler_(materials)

   Filler can have a negative or positive effect on fatigue resistance depending on the filler type and shape. In general fillers create small discontinuities in the matrix. This can contribute to crack initiation point. If the filler is brittle fatigue resistance will be low, whereas if the filler is very ductile the composite will be fatigue ...