When.com Web Search

  1. Ads

    related to: 1 2 jic dimensions

Search results

  1. Results From The WOW.Com Content Network
  2. JIC fitting - Wikipedia

    en.wikipedia.org/wiki/JIC_fitting

    JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface. JIC (Joint Industry Council) fittings are widely used in fuel delivery and fluid power applications, especially where high pressure (up to 10,000 pounds per square inch (690 bar)) is involved.

  3. AN thread - Wikipedia

    en.wikipedia.org/wiki/AN_thread

    AN sizes range from -2 (dash two) to -32 in irregular steps, with each step equating to the OD (outside diameter) of the tubing in 1 ⁄ 16-inch increments. Therefore, a -8 AN size would be equal to 12 -inch OD tube.

  4. Flare fitting - Wikipedia

    en.wikipedia.org/wiki/Flare_fitting

    The most common flare fitting standards in use today are the 45° SAE flare [2] [3],the 37° JIC flare, and the 37° AN flare. For high pressure, flare joints are made by doubling the tube wall material over itself before the bell end is formed. The double flare avoids stretching the cut end where a single flare may crack.

  5. Machine taper - Wikipedia

    en.wikipedia.org/wiki/Machine_taper

    The MT2 taper is the size most often found in drill presses up to 13 mm (12") capacity. Stub (short) versions, the same taper angle but a little over half the usual length, are occasionally encountered for the whole number sizes from 1 through 5.

  6. Taking This Daily Vitamin Could Help You Live Months Longer ...

    www.aol.com/lifestyle/taking-daily-vitamin-could...

    The scientists looked at a bunch of biomarkers, and found that people who took 1 gram of omega-3 fatty acids daily slowed down their biological aging across several areas by up to four months.

  7. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

  8. Trump will inherit a housing market creaking under the strain ...

    www.aol.com/finance/trump-inherit-housing-market...

    Trump’s administration has promised to slash mortgage rates and home prices by instituting mass deportations of undocumented immigrants and easing federal regulations around building and land use.

  9. Despite 20 knife wounds and 11 bruises, Ellen Greenberg’s ...

    www.aol.com/despite-20-knife-wounds-11-012600179...

    Ellen Greenberg was found dead in 2011 in her Philadelphia apartment with 20 knife wounds and numerous bruises. Authorities ruled her death a suicide. Fourteen years later, the pathologist who ...