Search results
Results From The WOW.Com Content Network
A pusher aircraft is a type of aircraft using propellers placed behind the engines. Pushers may be classified according to lifting surfaces layout (conventional or 3 surface, canard, joined wing, tailless and rotorcraft) as well as engine/propeller location and drive. For historical interest, pusher aircraft are also classified by date.
In aviation, a tractor configuration is a propeller-driven fixed-wing aircraft with its engine mounted with the propeller in front, so that the aircraft is "pulled" through the air. This is the usual configuration; the pusher configuration places the airscrew behind, and "pushes" the aircraft forward. Through common usage, the word "propeller ...
The classic "Farman" pusher had the propeller "mounted (just) behind the main lifting surface" with the engine fixed to the lower wing or between the wings, immediately forward of the propeller in a stub fuselage (that also contained the pilot) called a nacelle. The main difficulty with this type of pusher design was attaching the tail (empennage).
A pusher aircraft is a type of aircraft using propellers placed behind the engines and may be classified according to engine/propeller location and drive as well as the lifting surfaces layout (conventional or 3 surface, canard, joined wing, tailless and rotorcraft), Some aircraft have a Push-pull configuration with both tractor and pusher engines.
Waldo Waterman's first flying wing aircraft was the unofficially named Waterman Whatsit, a pusher configuration low swept-wing monoplane with fins near its wing tips. The Whatsit also featured a wing-mounted tricycle undercarriage and a trim foreplane. Powered by a 100 hp (75 kW) Kinner K-5 5-cylinder radial pusher engine, it first flew in 1932 ...
These were mounted on the middle wing and supported by additional struts, configured as two outboard tandem tractor/pusher pairs and one central pusher. In addition to its triplane wing configuration, the Fury had a biplane tailplane with three rudders, mounted on a single vertical fin similar to the Curtiss triplane.
The Arpin A-1 [1] [2] was a low-wing monoplane of wooden construction and plywood covered. The empennage was carried on a pair of diamond cross section booms mounted on the rear wing spar at the edge of the centre section. The fins were tall, with a slight extension below the boom and carrying unbalanced rudders.
Twin booms extend aft of the wings to the vertical stabilizers, with the rear engine between them. The horizontal stabilizer is aft of the pusher propeller, mounted between and connecting the two booms. [1] The combined tractor and pusher engines produce centerline thrust and a unique sound. [2]