Ad
related to: how to install air intake housing on ford transit connect 2013 xl cargo van
Search results
Results From The WOW.Com Content Network
In 2004, Ford of Europe created the Ford Transit Connect X-Press, based upon a pre-production Transit Connect prototype and a 212 hp 2.0L engine of the Ford Focus RS. [47] Using a short-wheelbase cargo van with a rear liftgate, the X-Press is fitted with the front suspension, four-wheel disc brakes, and steering of the Focus RS. [ 48 ]
A shaker scoop (sometimes called a shaker hood scoop or a shaker hood) is an automobile term for an air intake for combustion air that is mounted directly on top of the engine's air cleaner and protrudes through a hole in the hood. Since it is fastened directly to the engine, it moves with the engine's movement and vibration on its mountings ...
Warm air from inside the engine bay is used opposed to air taken from the generally more restrictive stock intake. Warmer air is less dense, and thus contains less oxygen to burn fuel in. The car's ECU compensates by opening the throttle wider to admit more air. This, in turn, decreases the resistance the engine must overcome to suck air in.
The pump's air intake is filtered by a rotating screen or the vehicle air filter to exclude dirt particles large enough to damage the system. Air is delivered under light pressure to the injection point(s). A check valve prevents exhaust forcing its way back through the air injection system, which would damage the pump and other components.
Carbon build-up in the intake manifold will occur when blow-by gases are allowed to permanently contaminate the intake air because of a failing PCV system. [12] Carbon build-up or oil sludge from blow-by gases on intake valves are usually not a problem in port injected engines. This is due to the fact that the fuel hits the intake valves on the ...
For an automobile engine the components through which the air flows to the engine cylinders, are collectively known as an intake system [4] and may include the inlet port and valve. [5] An intake for a hydroelectric power plant is the capture area in a reservoir which feeds a pressure pipe, or penstock , or into an open canal.
The air which is expelled fills the manifold with higher pressure, and on subsequent intake strokes the air which is taken in is at a higher pressure. Late intake valve closing has been shown to reduce pumping losses by 40% during partial load conditions, and to decrease nitric oxide emissions by 24%. Peak engine torque showed only a 1% decline ...
The Henninger Tower had two rotating restaurants at the height of 101 and 106 meters and an open-air observation deck at the height of 110 meters. The tower closed to the public in October 2002 and was demolished in 2013 to be replaced by a 140 m (459 ft) tall residential tower, which is externally inspired by the old Henninger Turm.