Search results
Results From The WOW.Com Content Network
A ferrite loopstick antenna, a small loop used for AM reception in a portable radio, consisting of a wire wound around a ferrite core; the most common type of loop antenna today. A loop antenna is a radio antenna consisting of a loop or coil of wire, tubing, or other electrical conductor , that for transmitting is usually fed by a balanced ...
High-leg delta (also known as wild-leg, stinger leg, bastard leg, high-leg, orange-leg, red-leg, dog-leg delta) is a type of electrical service connection for three-phase electric power installations. It is used when both single and three-phase power is desired to be supplied from a three phase transformer (or transformer bank).
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
Often random wire antennas are also (inaccurately) referred to as long-wire antennas.There is no accepted minimum size, but actual long-wire antennas must be greater than at least a quarter-wavelength ( 1 / 4 λ) or perhaps greater than a half ( 1 / 2 λ) at the frequency the long wire antenna is used for, and even a half-wave may only be considered "long-ish" rather than "truly ...
The Carter system, also known as the Chicago system, was a method of wiring three-way switches in the era of early knob-and-tube wiring. This now-obsolete wiring method has been prohibited by the USA National Electrical Code since 1923, [2] even in new knob-and-tube installations which are still permitted under certain circumstances. This ...
The typical height of a 'T' antenna is shorter than the quarter wavelength required for resonance. A 'T' antenna is distinguished from the similar 'L' antenna by the place where the dangling, radiating wire attaches to the horizontal cross wire: For the 'T' antenna the dangling wire attaches to the exact center of the top horizontal wire.
Group the cables involved in the ground loop into a bundle or snake. [3] The ground loop still exists, but the two sides of the loop are close together, so stray magnetic fields induce equal currents in both sides, which cancel out. Break in the shield Create a break in the signal cable shield conductor. [5] The break should be at the load end.
A quad antenna is a type of directional wire radio antenna used on the HF and VHF bands. A quad is a Yagi–Uda antenna ("Yagi") made from loop elements instead of dipoles: It consists of a driven element and one or more parasitic elements ; however in a quad, each of the loop elements may be square, round, or some other shape.