Ads
related to: 1 4 inch hardboard
Search results
Results From The WOW.Com Content Network
Tempered hardboard is used in construction siding. Perforated hardboard. Perforated hardboard, also called pegboard, is tempered hardboard that has a uniform array of 1 ⁄ 8-or-1 ⁄ 4-inch (3.2 or 6.4 mm) holes in it, into which tool-hanging hooks or store fixtures can be placed.
Homasote is used in theatrical sets as a noise deadening layer for stage platforms consisting of a 3 ⁄ 4-inch (19 mm) plywood sublayer, a 1 ⁄ 2-inch (13 mm) Homasote layer, and a 1 ⁄ 4-inch (6 mm) Masonite top layer.
Standard perforated hardboard is made of wood fibers, usually with the addition of resin, ... Inch based 1 in (25.4 mm) 1 ...
In 1961, at a meeting in Scottsdale, Arizona, the Committee on Grade Simplification and Standardization agreed to what is now the current U.S. standard: in part, the dressed size of a 1-inch (nominal) board was fixed at 3 ⁄ 4 inch; while the dressed size of 2 inch (nominal) lumber was reduced from 1 + 5 ⁄ 8 inch to the current 1 + 1 ⁄ 2 inch.
The beams are continuously formed, so the length of the beam is limited only to the maximum length that can be handled and transported. Typical widths are 3 + 1 ⁄ 2, 5 + 1 ⁄ 4 or 7 inches (89, 133 or 178 mm); typical depths are 9 + 1 ⁄ 2, 11 + 7 ⁄ 8, 14, 16 and 18 inches (240, 300, 360, 410 and 460 mm). Typically the beams are made to a ...
Masonite board Back side of a masonite board Isorel, c. 1920 Quartrboard, [1] Masonite Corporation, c. 1930. Masonite, also called Quartboard or pressboard, [2] is a type of engineered wood made of steam-cooked and pressure-molded wood or paper fibers. The fibers form a stiff, dense material in a range of weights. [3]
Composite deck boards are sold in either grooved or solid sided versions. The grooved composite board is fastened with hidden deck fasteners or clips, while the solid board is typically face-screwed. Most composite deck board manufacturers produce lengths of 12, 16, or 20 feet (3.7, 4.9, or 6.1 m), 5 + 1 ⁄ 2 by 3 ⁄ 4 inch (140 mm × 19 mm).
Depending on the diameter of the log, cuts are made from 4 + 1 ⁄ 2 to 6 + 1 ⁄ 2 inches (110 to 170 mm) deep along the full length of the log. Each time the log turns for the next cut, it is rotated 5 ⁄ 8 inch (16 mm) until it has turned 360°. This gives the radially sawn clapboard its taper and true vertical grain.