When.com Web Search

  1. Ads

    related to: waterproofing basement walls from outside paint

Search results

  1. Results From The WOW.Com Content Network
  2. Basement waterproofing - Wikipedia

    en.wikipedia.org/wiki/Basement_waterproofing

    Waterproofing a structure from the exterior is the only method the U.S. International Building Code (IBC) recognizes as adequate to prevent structural damage caused by water intrusion. Waterproofing an existing basement begins with excavating to the bottom sides of the footings. Once excavated, the walls are then power washed and allowed to dry.

  3. Vertical damp proof barrier - Wikipedia

    en.wikipedia.org/wiki/Vertical_damp_proof_barrier

    Modern solutions take the form of a plastic membrane, often pre-coated with adhesive and a "peel off" paper that is applied to the outside of the structure before it is buried. Usually, a "priming coat" of bitumous paint has to be applied first. It often comes in one metre wide rolls and is installed with a 100 mm overlap.

  4. Waterproofing - Wikipedia

    en.wikipedia.org/wiki/Waterproofing

    Damp proofing is another aspect of waterproofing. Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an ...

  5. Damp proofing - Wikipedia

    en.wikipedia.org/wiki/Damp_proofing

    A DPC layer is usually laid below all masonry walls, regardless if the wall is a load bearing wall or a partition wall. A damp-proof membrane (DPM) is a membrane material applied to prevent moisture transmission. A common example is polyethylene sheeting laid under a concrete slab to prevent the concrete from gaining moisture through capillary ...

  6. Vapor barrier - Wikipedia

    en.wikipedia.org/wiki/Vapor_barrier

    Vapor retarder paints (for the air-tight drywall system, for retrofits where finished walls and ceilings will not be replaced, or for dry basements: can break down over time due to being chemically based). Extruded polystyrene or foil-faced foam board insulation. Exterior grade plywood, 0.70 US perm (40 SI perm).

  7. Bituminous waterproofing - Wikipedia

    en.wikipedia.org/wiki/Bituminous_waterproofing

    From 1905 to 1988, The Paraffine Paint Co. of San Francisco had Malthoid as a trademark for waterproof and weatherproof building and roofing materials made of paper and felt in whole or in part. [13] However, it had become well known before that. [14] About 1913, Paraffine promoted its Malthoid roofing materials with a 16-page booklet. [15]

  1. Ads

    related to: waterproofing basement walls from outside paint