Ads
related to: maximum staircase riser height for stairs interior wall
Search results
Results From The WOW.Com Content Network
The dimensions of a stair, in particular the rise height and going of the steps, should remain the same along the stairs. [14] The following stair dimensions are important: The rise height or rise of each step is measured from the top of one tread to the next. It is not the physical height of the riser; the latter excludes the thickness of the ...
A storey pole (or story pole, storey rod, [1] story stick, [2] jury stick, [3] scantling, [4] scantillon [5]) is a length of narrow board usually cut to the height of one storey. [6] It is used as a layout tool for any kind of repeated work in carpentry including stair-building , framing , timber framing , siding , brickwork , and setting tiles.
A stairwell or stair room is a room in a building where a stair is located, and is used to connect walkways between floors so that one can move in height. [1] Collectively, a set of stairs and a stairwell is referred to as a staircase or stairway. In buildings with several housing units, a stairway can be a necessary common area for getting to ...
Need help? Call us! 800-290-4726 Login / Join. Mail
Hong Kong law Chapter 123F, Building (Planning) Regulations, Regulation 23 sect 3 sub-paragraph (a) defined that: Subject to sub-paragraph (b), for the purposes of regulations 19, 20, 21 and 22, the gross floor area of a building shall be the area contained within the external walls of the building measured at each floor level (including any floor below the level of the ground), together with ...
A dog-leg staircase A quarter-landing, on a dog-leg staircase, is made into an architectural feature, by the use of arches, vaulting and stained glass. A dog-leg is a configuration of stairs between two floors of a building, often a domestic building, in which a flight of stairs ascends to a quarter-landing before turning at a right angle and continuing upwards. [1]
Interior loadbearing walls are framed in the same way as exterior walls. Studs are usually 1 + 1 ⁄ 2 in × 3 + 1 ⁄ 2 in (38 mm × 89 mm) lumber spaced at 16 in (410 mm) on center. This spacing may be changed to 12 or 24 in (300 or 610 mm) depending on the loads supported and the type and thickness of the wall finish used.
A structure of shear walls in the center of a large building—often encasing an elevator shaft or stairwell—form a shear core. In multi-storey commercial buildings, shear walls form at least one core (Figure 3). From a building services perspective, the shear core houses communal services including stairs, lifts, toilets and service risers.