Search results
Results From The WOW.Com Content Network
The negative swing of the output will not dip below about −0.6 V, assuming a silicon PN diode. [1] A clamper (or clamping circuit or clamp) is an electronic circuit that fixes either the positive or the negative peak excursions of a signal to a defined voltage by adding a variable positive or negative DC voltage to it. [2]
A transient-voltage-suppression diode can respond to over-voltages faster than other common over-voltage protection components such as varistors or gas discharge tubes. The actual clamping occurs in roughly one picosecond, but in a practical circuit the inductance of the wires leading to the device imposes a higher limit. This makes transient ...
Baker clamp is a generic name for a class of electronic circuits that reduce the storage time of a switching bipolar junction transistor (BJT) by applying a nonlinear negative feedback through various kinds of diodes. The reason for slow turn-off times of saturated BJTs is the stored charge in the base.
The circuits are now known as Baker clamps. One of those clamp circuits used a single germanium diode to clamp a silicon transistor in a circuit configuration that is the same as the Schottky transistor. [22]: 11, 30 The circuit relied on the germanium diode having a lower forward voltage drop than a silicon diode would have.
The circuits are now known as Baker clamps. One of those clamp circuits used a single germanium diode to clamp a silicon transistor in a circuit configuration that is the same as the Schottky transistor. [2]: 11, 30 The circuit relied on the germanium diode having a lower forward voltage drop than a silicon diode would have.
In Figure 2, a flyback diode was added in antiparallel with the solenoid. Instead of spiking to -300 V, the flyback diode only allows approximately -1.4 V of potential to be built up (-1.4 V is a combination of the forward bias of the 1N4007 diode (1.1 V) and the foot of wiring separating the diode and the solenoid [dubious – discuss]). The ...
Diode circuit implementing AND in active-high logic. Note: in analog implementation exact output currents will be different from +5V supply. This circuit mirrors the previous gate: the diodes are reversed so that each input connects to the cathode of a diode and all anodes are connected together to the output, which has a pull-up resistor.
While standard silicon diodes have a forward voltage drop of about 0.7 V and germanium diodes 0.3 V, Schottky diodes' voltage drop at forward biases of around 1 mA is in the range of 0.15 V to 0.46 V (see the 1N5817 [6] and 1N5711 [7]), which makes them useful in voltage clamping applications and prevention of transistor saturation.