Search results
Results From The WOW.Com Content Network
The peak-to-average power ratio (PAPR) is the peak amplitude squared (giving the peak power) divided by the RMS value squared (giving the average power). [1] It is the square of the crest factor. When expressed in decibels , crest factor and PAPR are equivalent, due to the way decibels are calculated for power ratios vs amplitude ratios .
Audio power is the electrical power transferred from an audio amplifier to a loudspeaker, measured in watts.The electrical power delivered to the loudspeaker, together with its efficiency, determines the sound power generated (with the rest of the electrical power being converted to heat).
A Band-pass filter showing the centre frequency(Fc), the lower(F1) and upper(F2) cut off frequencies and the bandwidth. The upper and lower cut-off frequencies are defined as the point where the amplitude falls to 3 dB below the peak amplitude. The bandwidth is the distance between the upper and lower cut-off frequencies, and is the range of ...
Example: A 16-bit system has 2 16 different possibilities, from 0 – 65,535. The smallest signal without dithering is 1, so the number of different levels is one less, 2 16 − 1. So for a 16-bit digital system, the Dynamic Range is 20·log(2 16 − 1) ≈ 96 dB. Sample accuracy/synchronisation Not as much a specification as an ability.
A signal at +4 dBu is equivalent to a sine wave signal with a peak amplitude of approximately 1.736 volts, or any general signal at approximately 1.228 V RMS. Peak-to-peak (sometimes abbreviated as p-p ) amplitude (V PP ) refers to the total voltage swing of a signal, which is double the peak amplitude of the signal.
Decibels relative to full scale (dBFS or dB FS) is a unit of measurement for amplitude levels in digital systems, such as pulse-code modulation (PCM), which have a defined maximum peak level. The unit is similar to the units dBov and decibels relative to overload (dBO). [1] The level of 0 dBFS is assigned to the maximum possible digital level. [2]
This quasi-peak measurement is also called psophometric weighting. This was once more important because outside broadcasts were carried over 'music circuits' that used telephone lines, with clicks from Strowger and other electromechanical telephone exchanges. It now finds fresh relevance in the measurement of noise on computer 'Audio Cards ...
Assuming a full-scale sine wave signal (that is, the quantizer is designed such that it has the same minimum and maximum values as the input signal), the quantization noise approximates a sawtooth wave with peak-to-peak amplitude of one quantization level [11] and uniform distribution. In this case, the SNR is approximately