Search results
Results From The WOW.Com Content Network
The transponder gets its altitude information from an encoding altimeter mounted behind the instrument panel that communicates via the Gillham code. Gillham code is a zero-padded 12-bit binary code using a parallel nine- [ 1 ] to eleven-wire interface , [ 2 ] the Gillham interface , that is used to transmit uncorrected barometric altitude ...
QFE - is the barometric altimeter setting that causes an altimeter to read zero when at the reference datum of a particular airfield (in practice, the reference datum is either an airfield center or a runway threshold). In ISA temperature conditions the altimeter will read the height above the airfield/runway in the vicinity of the airfield.
In aviation, a flight level (FL) is an aircraft's altitude as determined by a pressure altimeter using the International Standard Atmosphere. It is expressed in hundreds of feet or metres. The altimeter setting used is the ISA sea level pressure of 1013 hPa or 29.92 inHg. The actual surface pressure will vary from this at different locations ...
When flying at a flight level, the altimeter is always set to standard pressure (29.92 inHg or 1013.25 hPa). On the flight deck, the definitive instrument for measuring altitude is the pressure altimeter, which is an aneroid barometer with a front face indicating distance (feet or metres) instead of atmospheric pressure.
Old altimeters were typically limited to displaying the altitude when set between 950 mb and 1030 mb. Standard pressure, the baseline used universally, is 1013.25 hectopascals (hPa), which is equivalent to 1013.25 mb or 29.92 inches of mercury (inHg).
The altimeter, which is usually a barometer calibrated in units of distance instead of atmospheric pressure, can therefore be set in such a way as to indicate the height of the aircraft above ground. This is done by communicating with the control tower of the airport (to get the current surface pressure) and setting the altimeter so as to read ...
Pressure altimeter measuring atmospheric pressure, which decreases as altitude increases. Since atmospheric pressure varies with the weather, too, a recent local measure of the pressure at a known altitude is needed to calibrate the altimeter. Stereoscopy in aerial photography. Aerial lidar and satellite laser altimetry.
FATPL - pre-takeoff checks. Fuel, Altimeters, Transponder, Pitot Heat, Landing Light. [2] FREDA - en-route checks; GUMPS - pre-landing checks; HASELL - checks before aerial manoeuvres; IMSAFE - personal wellness checks; OWLS - checks to assess an unprepared surface for a precautionary landing; PARE - spin recovery technique; PAVE - pre-flight ...