Ads
related to: proper placement of cable clamps chartwireandcableyourway.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Usually, the lines are fixed by clamping them into single cable clamps made of plastic or metal. Another possibility is to use so called cord grips which consist of weaved wire strands that put a grip around the cables. [3] A more cable-friendly alternative is attaching the lines to special strain relief plates using common cable ties. In case ...
Cables usually are secured with special fittings where they enter electrical apparatus; this may be a simple screw clamp for jacketed cables in a dry location, or a polymer-gasketed cable connector that mechanically engages the armour of an armoured cable and provides a water-resistant connection.
A guy-wire, guy-line, guy-rope, down guy, or stay, also called simply a guy, is a tensioned cable designed to add stability to a freestanding structure. They are used commonly for ship masts , radio masts , wind turbines , utility poles , and tents .
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
In both those instances the white wire should be identified as being hot, usually with black tape inside junction boxes. The neutral wire is identified by gray or white insulated wire, perhaps using stripes or markings. With lamp cord wire the ribbed wire is the neutral, and the smooth wire is the hot. NEC 2008 400.22(f) allows surface marking ...
A cable gland (more often known in the U.S. as a cord grip, cable strain relief, cable connector or cable fitting) is a device designed to attach and secure the end of an electrical cable to the equipment. [1]
EMT itself is not threaded, but can be used with threaded fittings that clamp to it. Lengths of conduit are connected to each other and to equipment with clamp-type fittings. Like GRC, EMT is more common in commercial and industrial buildings than in residential applications. EMT is generally made of coated steel, though it may be aluminum.
Alligator and Crocodile clips – conductive clamps used for temporary connections, e.g. jumper cables; Board to board connectors – e.g. card-edge connectors or FPGA mezzanine connectors; Twist-on wire connectors (e.g. wire nuts) – used in low-voltage power circuits for wires up to about 10 AWG; Wire wrapping – used in older circuit boards