Search results
Results From The WOW.Com Content Network
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
Standing pedals in a Saab Sonett. Pedals either hang from the bulkhead or stand on the floor. The arrangement is the same for both right- and left-hand traffic. 1969 Citroen DS Pallas interior with hydraulic gear selector mounted top right of steering column with a single spoke steering wheel. Note the so-called mushroom brake pedal.
Here the seat controls are located on the door panels, next to the memory seat controls. Above the seat settings are the memory control settings which also set the mirrors and pedals. A power seat in an automobile is a seat in a passenger compartment that can be adjusted using a button, switch or joystick and a set of small electric motors ...
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
The power seat adjustments in a Lincoln Town Car. The seat controls are located on the door panels, next to the memory seat controls. Above the seat settings are the memory control settings that also set the mirrors and foot pedals. Some car seat systems are set up with a battery-powered automatic control to adjust how the seat sits in the car.
Although the dead pedal serves no mechanical function in the car, many car manufacturers opt to implement it because it provides a number of ergonomic benefits to the driver. In manual transmission cars, the dead pedal is designed to promote a smoother actuation of the clutch by keeping the driver's foot in the same plane as the pedal. [1]
A traditional method of hill starts in a manual transmission car is to use the parking brake (also called "handbrake", "emergency brake", or "e-brake") to hold the vehicle stationary. This means that the driver's right foot is not needed to operate the brake pedal, freeing it up to be used on the accelerator pedal instead.
Jeep exhibited a concept car named Commander during the 1999 auto show circuit. The concept featured an experimental direct methanol fuel cell that produced electricity to charge a nickel–metal hydride battery pack. Full-time four-wheel drive was by a severe duty electric motor on each axle. [2]