Ad
related to: dtc codes p1345 chart 1 3 mm paperboard square hole
Search results
Results From The WOW.Com Content Network
The measurement value is averaged so that each sensor gives one measurement value per one data box which is typically from 5 mm to one centimeter of web width. For a 1 meter wide web, for instance, 100 - 200 measurement values are taken. These measurement values from a single scan (profile points) are called 'raw profiles'.
The codes given in the chart below usually tell the length and width of the components in tenths of millimeters or hundredths of inches. ... 2.9 mm × 1.3 mm × 1.3 ...
Unified Diagnostic Services (UDS) is a diagnostic communication protocol used in electronic control units (ECUs) within automotive electronics, which is specified in the ISO 14229-1. [1] It is derived from ISO 14230-3 ( KWP2000 ) and the now obsolete ISO 15765 -3 (Diagnostic Communication over Controller Area Network (DoCAN) [ 2 ] ).
An Automated Optical Inspection device. Automated optical inspection (AOI) is an automated visual inspection of printed circuit board (PCB) (or LCD, transistor) manufacture where a camera autonomously scans the device under test for both catastrophic failure (e.g. missing component) and quality defects (e.g. fillet size or shape or component skew).
OBD-II PIDs (On-board diagnostics Parameter IDs) are codes used to request data from a vehicle, used as a diagnostic tool.. SAE standard J1979 defines many OBD-II PIDs. All on-road vehicles and trucks sold in North America are required to support a subset of these codes, primarily for state mandated emissions inspections.
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
It is a thin, rigid sheet with holes pre-drilled at standard intervals across a grid, usually a square grid of 0.1 inches (2.54 mm) spacing. These holes are ringed by round or square copper pads, though bare boards are also available. Inexpensive perfboard may have pads on only one side of the board, while better quality perfboard can have pads ...
The internal-drive square socket for screws (as well as the corresponding triangular socket drive) had been conceived several decades before the invention of the Robertson screw and driver. An earlier patent covering both square-socket- and triangle-socket -drive wood screws, U.S. patent 161,390 , was issued to Allan Cummings of New York City ...