When.com Web Search

  1. Ads

    related to: exterior water shut off valve

Search results

  1. Results From The WOW.Com Content Network
  2. Curb box - Wikipedia

    en.wikipedia.org/wiki/Curb_box

    A curb box (also known as a valve box, buffalo box, b-box, or in British English stopcock chamber) is a vertical cast iron sleeve, accessible from the public way, housing the shut-off valve (curb cock or curb stop) for a property's water service line.

  3. Backflow prevention device - Wikipedia

    en.wikipedia.org/wiki/Backflow_prevention_device

    [example needed] A typical backflow assembly has test cocks and shut-off valves, and must be tested when installed, if relocated or repaired, and also on a periodic basis. [citation needed] In the US, the Environmental Protection Agency (EPA) holds local water suppliers responsible for maintaining a certain amount of purity in potable water ...

  4. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Cone valves or ball valves are another alternative. These are commonly found as the service shut-off valves in more-expensive water systems and usually found in gas taps (and, incidentally, the cask beer taps referred to above). They can be identified by their range of motion—only 90°—between fully open and closed.

  5. 8 Ways to Winter-Proof Your Home and Your Energy Bill - AOL

    www.aol.com/lifestyle/8-ways-winter-proof-home...

    7. Find where your main water shut-off is. If you don't know where this is in your home, now is the time to find it. It looks like a garden tap, or it could be a lever and is usually found under ...

  6. Home inspection checklist for buyers: What to know - AOL

    www.aol.com/finance/home-inspection-checklist...

    Shut-off valves Built-in appliances. Visible plumbing under sink Any and all fixtures Tub Shower, shower head and caulking Sink and faucet Ceiling Exhaust fan Toilet. Doors and windows Garage ...

  7. Atmospheric vacuum breaker - Wikipedia

    en.wikipedia.org/wiki/Atmospheric_vacuum_breaker

    It is usually constructed of brass and resembles a 90-degree elbow with a hood on its top to allow air to enter the water system if a siphon attempts to form. Inside this elbow is a poppet valve that is held "up" by the water pressure found in the system, closing the air entrance to the device. If the pressure in the "upstream side" is reduced ...