Search results
Results From The WOW.Com Content Network
Uses of pneumatic pressure switches include: Switch a household well water pump automatically when water is drawn from the pressure tank. Switching off an electrically driven gas compressor when a set pressure is achieved in the reservoir; Switching off a gas compressor, whenever there is no feed in the suction stage. in-cell charge control in ...
There are three different methods for detection of water shortage: Pressure switch on suction manifold or float switch/electrode relay in the supply tank: Dry-running protection with pressure/level switch. Measurement of inlet pressure in the suction manifold by means of an analogue pressure transmitter: Dry-running protection with pressure ...
A simple control system for a water well. Referring to the figure on the left, a submersible water pump is installed in a well. The pressure switch turns the water pump on when it senses a pressure that is less than P lo and turns it off when it senses a pressure greater than P hi. While the pump is on, the pressure tank fills up.
The combination of the downward movement of the tubing and the upward movement of the fluid (or piston effect) results in an increase in pressure throughout the well. This increase in pressure is commonly called Surge pressure. Upward movement of the tubing (tripping out) also affects the pressure at the bottom of the well.
A back-pressure regulator, back-pressure valve, pressure sustaining valve or pressure sustaining regulator is a control valve that maintains the set pressure at its inlet side by opening to allow flow when the inlet pressure exceeds the set value. It differs from an over-pressure relief valve in that the over-pressure valve is only intended to ...
These pumps, often submersible and powered by electricity, can access water reserves located much deeper than shallow wells, ensuring a consistent supply even during periods of drought. They include different kinds of pumps, most of them submersible pumps: Hand pump, manually operated; Injector, a jet-driven pump; Mechanical or rotary lobe pump ...
In the context of oil wells, pumping is a routine operation involving injecting fluids into the well. Pumping may either be done by rigging up to the kill wing valve on the Xmas tree or, if an intervention rig up is present pumping into the riser through a T-piece (a small section of riser with a connection on the side).
The maximum pressure rating of a metering pump is actually the top of the discharge pressure range the pump is guaranteed to pump against at a reasonably controllable flow rate. The pump itself is a pressurizing device often capable of exceeding its pressure rating, although not guaranteed to.