Ads
related to: hard drive transfer cable best buyebay.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
Historical Word serial interfaces connect a hard disk drive to a bus adapter [b] with one cable for combined data/control. (As for all early interfaces above, each drive also has an additional power cable, usually direct to the power supply unit.) The earliest versions of these interfaces typically had an 8 bit parallel data transfer to/from ...
USB bridge cables, or data transfer cables can be found within the market, offering direct PC to PC connections. A bridge cable is a special cable with a chip and active electronics in the middle of the cable. The chip in the middle of the cable acts as a peripheral to both computers and allows for peer-to-peer communication between the computers.
The Serial ATA interface was designed primarily for interfacing with hard disk drives (HDDs), doubling its native speed with each major revision: maximum SATA transfer speeds went from 1.5 Gbit/s in SATA 1.0 (standardized in 2003), through 3 Gbit/s in SATA 2.0 (standardized in 2004), to 6 Gbit/s as provided by SATA 3.0 (standardized in 2009). [9]
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
Enhanced Small Disk Interface (ESDI) is a hard disk drive interface designed by Maxtor Corporation in 1983 to be a follow-on to the ST-412/506 interface. [1] ESDI improved on ST-506 by moving certain parts that were traditionally kept on the controller (such as the data separator) into the drives themselves, and also generalizing the control bus such that more kinds of devices (such as ...
Additionally, the larger 3.5" drive will get the 12 V it needs to power its disk spindle motor. Thus a bare hard drive may be attached directly to the computer, powered by the unique cable, where it will run at full SATA speeds, without the necessity of placing the hard drive into an external enclosure.