Ads
related to: emissions purge valve replacement cost lennox system
Search results
Results From The WOW.Com Content Network
A NO x adsorber is designed to reduce oxides of nitrogen emitted in the exhaust gas of a lean burn internal combustion engine.Lean burn engines, particularly diesels, present a special challenge to emission control system designers because of the relatively high levels of O 2 (atmospheric oxygen) in the exhaust gas.
An onboard refueling vapor recovery system (ORVR) is a vehicle fuel vapor emission control system that captures volatile organic compounds (VOC, potentially harmful vapors) during refueling. [ 1 ] [ page needed ] There are two types of vehicle fuel vapor emission control systems: the ORVR, and the Stage II vapor recovery system. [ 2 ]
The program included a biennial and change of ownership testing, "BAR 84" emissions test plus a visual and functional inspection of various emission control components, a $50 repair cost limit (unless emission device tampering was noted), licensing shops to perform smog checks and mechanic certification for emissions repair competence. [18]
PCV valve on Ford Taunus V4 engine (feeding from left side valve cover into the inlet manifold) A crankcase ventilation system (CVS) removes unwanted gases from the crankcase of an internal combustion engine. The system usually consists of a tube, a one-way valve and a vacuum source (such as the inlet manifold).
EGR valve the top of box on top of the inlet manifold of a Saab H engine in a 1987 Saab 90. In internal combustion engines, exhaust gas recirculation (EGR) is a nitrogen oxide (NO x) emissions reduction technique used in petrol/gasoline, diesel engines and some hydrogen engines. [1]
CEM systems can also measure air flow, flue gas opacity and moisture. A monitoring system that measures particulate matter is referred to as a PEMS. In the U.S., the EPA requires a data acquisition and handling system to collect and report the data. Measurements of concentration can be converted to mass/hour by including flow rate measurements.
The system can be flushed with an inert gas to reduce the concentration of oxygen so that when the flammable gas is admitted, an ignitable mixture cannot form. In NFPA 56, [1] this is known as purge-into-service. In combustion engineering terms, the admission of inert gas dilutes the oxygen below the limiting oxygen concentration.
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause.