Search results
Results From The WOW.Com Content Network
A multi-link suspension is a type of independent vehicle suspension having three or more control links per wheel. [1] These arms do not have to be of equal length, and may be angled away from their "obvious" direction. It was first introduced in the late 1960s on the Mercedes-Benz C111 [2] and later on their W201 and W124 series. [3] [4]
Double wishbone suspension; arms and knuckle painted yellow. In automobiles, a double wishbone suspension is an independent suspension design using two (occasionally parallel) wishbone-shaped arms to locate the wheel. Each wishbone or arm has two mounting points to the chassis and one joint at the knuckle.
A short long arms suspension (SLA) is also known as an unequal-length double wishbone suspension. The upper arm is typically an A-arm and is shorter than the lower link, which is an A-arm or an L-arm, or sometimes a pair of tension/compression arms. In the latter case, the suspension can be called a multi-link, or dual-ball joint suspension.
The type of suspension (MacPherson strut or double wishbone suspension) Type of steering actuator (rack and pinion or recirculating ball) Location of the steering actuator in front of, or behind, the wheel centre; For the rear suspension there are many more possible suspension types, in practice.
The two arms, the spindle, and the body, form a four-bar link.Use of the linkage at the lower suspension connection of either a MacPherson strut or a short long arms suspension readily gives an effective virtual ball joint outboard of the spindle, which is very useful for a suspension designer, allowing negative scrub radius whilst allowing the ball joints to move in and thus out of the way of ...
In either case, the difference is that the single bottom wishbone is replaced by a pair of suspension links forming a trapezoidal four-bar linkage. This allows the kingpin to pivot about a pivot point nearer the center of the wheel's contact patch instead of the traditional pivot point at the ball joint of the bottom wishbone. [2]
This is a very confusing description of car suspension design. I read the article and was no wiser afterwards but I have a suggestion. I believe the term 'Multi-Link' should not be applied generally to any suspension system with multiple links, but specifically to the complex modern variations on the double wishbone (A arm).
The double-wishbone suspension can also be referred to as ‘double A-arm,’ though the arms themselves can be A-shaped, L-shaped, or even a single bar linkage. The complete TAK-4 independent suspension system set-up also includes a subframe which contains the axle differential, half shafts, and wheel ends with steering attachments and brakes.