When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Drain-waste-vent system - Wikipedia

   en.wikipedia.org/wiki/Drain-waste-vent_system

   A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.

3. Drain (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Drain_(plumbing)

   A drain cover is a cover with holes (e.g. a manhole) or a grating used to cover a drain, to prevent unwanted entry of foreign objects, or injury to people or animals. It allows drainage of liquids but prevents entry from large solid objects, and thus acts as a coarse filter. A sink drain cover is a drain cover used to cover the sink drain.

4. Effluent sewer - Wikipedia

   en.wikipedia.org/wiki/Effluent_sewer

   An alternative effluent sewer which is similar to the STEG system is the STEP system. Because of the vast reduction of solid wastes and the capture of fats, oils and grease (FOG) within the interceptor tank, a pumping system can be used to move the wastewater under pressure rather than a gravity driven conveyance system.

5. Vacuum sewer - Wikipedia

   en.wikipedia.org/wiki/Vacuum_sewer

   Schematic of a vacuum sewer system A vacuum toilet at Lau Fau Shan Roundabout in Hong Kong A portable vacuum sewer system on the underside of a train carriage, serving the vacuum toilet and sink inside the train. A vacuum sewer or pneumatic sewer system is a method of transporting sewage from its source to a sewage treatment plant.

6. Trap (plumbing) - Wikipedia

   en.wikipedia.org/wiki/Trap_(plumbing)

   In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.

7. Plumbing - Wikipedia

   en.wikipedia.org/wiki/Plumbing

   Plastic hot and cold supply piping for a sink Plastic pipe is in wide use for domestic water supply and drain-waste-vent (DWV) pipe. Principal types include: Polyvinyl chloride (PVC) was produced experimentally in the 19th century but did not become practical to manufacture until 1926, when Waldo Semon of BF Goodrich Co. developed a method to ...