Ads
related to: 50 ohm load resistor chartpasternack.com has been visited by 10K+ users in the past month
fairviewmicrowave.com has been visited by 10K+ users in the past month
Search results
Results From The WOW.Com Content Network
Using the Smith chart, the normalised impedance may be obtained with appreciable accuracy by plotting the point representing the reflection coefficient treating the Smith chart as a polar diagram and then reading its value directly using the characteristic Smith chart scaling. This technique is a graphical alternative to substituting the values ...
For example, in order to match an inductive load into a real impedance, a capacitor needs to be used. If the load impedance becomes capacitive, the matching element must be replaced by an inductor. In many cases, there is a need to use the same circuit to match a broad range of load impedance and thus simplify the circuit design.
For example, a 10 ohm resistor connected in parallel with a 5 ohm resistor and a 15 ohm resistor produces 1 / 1/10 + 1/5 + 1/15 ohms of resistance, or 30 / 11 = 2.727 ohms. A resistor network that is a combination of parallel and series connections can be broken up into smaller parts that are either one or the other.
1A12A2R3 - Unit 1, Assembly 12, Sub-assembly 2, Resistor 3 1A12A2U3 - Unit 1, Assembly 12, Sub-assembly 2, Inseparable Assembly 3 Especially valuable is the method of referencing and annotating cables plus their connectors within and outside assemblies.
For many systems, the terminator is a resistor, with a value chosen to match the characteristic impedance of the transmission line and chosen to have acceptably low parasitic inductance and capacitance at the frequencies relevant to the system. Examples include 75-ohm resistors often used to terminate 75-ohm video transmission coaxial cables.
A single in line (SIL) resistor package with 8 individual 47 ohm resistors. This package is also known as a SIP-9. One end of each resistor is connected to a separate pin and the other ends are all connected together to the remaining (common) pin – pin 1, at the end identified by the white dot.
Ad
related to: 50 ohm load resistor chartpasternack.com has been visited by 10K+ users in the past month