Ads
related to: wall mounted microphone rail system for music box and speakers outdoor wireless
Search results
Results From The WOW.Com Content Network
Small PA systems may extend to an entire building, such as a restaurant, store, elementary school or office building. A sound source such as a compact disc player or radio may be connected to a PA system so that music can be played through the system. Smaller, battery-powered 12 volt systems may be installed in vehicles such as tour buses or ...
During the installation phase, audio engineers ensure that high-power electrical components are safely installed and connected and that ceiling or wall-mounted speakers are properly mounted (or "flown") onto rigging. When the sound reinforcement components are installed, the audio engineers test and calibrate the system so that its sound ...
A miked guitar speaker in an isolation cabinet is run into another channel of the mixing console. The DI signal and miked guitar speaker can then be selectively blended, with the DI providing a more immediate, present, bright sound, and the microphone and guitar speaker providing a colored, distant, darker sound.
Boundary microphone (Audio-Technica ATM87R) A boundary microphone (or pressure zone microphone) is one or more small omnidirectional or cardioid condenser mic capsule(s) positioned near or flush with a boundary (surface) such as a floor, table, or wall. The capsule(s) is/are typically mounted in a flat plate or housing.
The Wall of Sound was an enormous sound reinforcement system designed in 1973 specifically for the Grateful Dead's live performances. The largest concert sound system built at that time, [1] [2] the Wall of Sound fulfilled lead designer Owsley "Bear" Stanley's desire for a distortion-free sound system that could also serve as its own monitoring ...
The height of a rack can vary from a few inches, such as in a broadcast console, to a floor-mounted rack whose interior is 45 rack units (200.2 centimetres or 78.82 inches) high. 42U is a common configuration. Many wall-mounted enclosures for industrial equipment use 19-inch racks.