Search results
Results From The WOW.Com Content Network
If there is a removable strainer device that fits into the fixed strainer, it is termed a strainer basket. The initial pipe that leads from the strainer to the trap is termed the tailpiece. Floor-mounted water closets seal to the toilet flange of the drain pipe by means of a wax ring. These are traditionally made out of beeswax.
A closet flange (the drainpipe flange to which a flush toilet is attached) is a specialized flange designed to be flush with the floor, allowing a toilet to be installed above it. The flange must be mechanically strong to accommodate slight misalignments or movements and resist corrosion.
PVC closet flange with steel flange, before installation. In plumbing, a closet flange (also known as a toilet flange) is a pipe fitting (specifically, a type of flange) that both mounts a toilet to the floor and connects the closet bend to a drain pipe. The name comes from the term "water closet", the traditional name for a toilet.
A compression fitting 15 mm isolating valve. A compression fitting is a fitting used in plumbing and electrical conduit systems to join two tubes or thin-walled pipes together. . In instances where two pipes made of dissimilar materials are to be joined (most commonly PVC and copper), the fittings will be made of one or more compatible materials appropriate for the connect
Internal parts of a typical globe valve. The body is the main pressure-containing structure of the valve and the most easily identified as it forms the mass of the valve.It contains all of the valve's internal parts that will come in contact with the substance being controlled by the valve.
A floor sink is a type of floor drain primarily used as an indirect waste receptor. It is generally deeper than a standard floor drain and can have a full or partial grate, or no grate as required to accommodate the indirect waste pipes. It usually has a dome strainer in the bottom to prevent splash-back.
A basket strainer is a design where the strainer is shaped like a basket and usually installed in a vertical system. The basket strainer is easier to clean, since debris is captured in the basket. It can also sometimes offer more straining surface area than a plate strainer, improving flow rates, or decreasing pressure loss through the strainer.
In domestic applications, traps are typically U, S, Q, or J-shaped pipe located below or within a plumbing fixture.An S-shaped trap is also known as an S-bend.It was invented by Alexander Cumming in 1775 but became known as the U-bend following the introduction of the U-shaped trap by Thomas Crapper in 1880.