Search results
Results From The WOW.Com Content Network
The hydroxyl value can be calculated using the following equation. Note that a chemical substance may also have a measurable acid value affecting the measured endpoint of the titration. The acid value ( AV ) of the substance, determined in a separate experiment, enters into this equation as a correction factor in the calculation of the hydroxyl ...
2 KOH + CO 2 → K 2 CO 3 + H 2 O. From the solution crystallizes the sesquihydrate K 2 CO 3 ·1.5H 2 O ("potash hydrate"). Heating this solid above 200 °C (392 °F) gives the anhydrous salt. In an alternative method, potassium chloride is treated with carbon dioxide in the presence of an organic amine to give potassium bicarbonate, which is ...
In chemical synthesis, the choice between the use of KOH and the use of NaOH is guided by the solubility or keeping quality of the resulting salt. The corrosive properties of potassium hydroxide make it a useful ingredient in agents and preparations that clean and disinfect surfaces and materials that can themselves resist corrosion by KOH. [17]
Aqueous alkaline solutions do not reject carbon dioxide (CO 2) so the fuel cell can become "poisoned" through the conversion of KOH to potassium carbonate (K 2 CO 3). [2] Because of this, alkaline fuel cells typically operate on pure oxygen, or at least purified air and would incorporate a 'scrubber' into the design to clean out as much of the ...
This gives the SCE a potential of +0.248 V vs. SHE at 20 °C and +0.244 V vs. SHE at 25 °C, [1] but slightly higher when the chloride solution is less than saturated. For example, a 3.5M KCl electrolyte solution has an increased reference potential of +0.250 V vs. SHE at 25°C while a 1 M solution has a +0.283 V potential at the same temperature.
Potassium hypochlorite is produced by the disproportionation reaction of chlorine with a solution of potassium hydroxide: [2]. Cl 2 + 2 KOH → KCl + KOCl + H 2 O. This is the traditional method, first used by Claude Louis Berthollet in 1789.
Pellets of soda lye (sodium hydroxide) Pellets of potash lye (potassium hydroxide)Lye is a hydroxide, either sodium hydroxide or potassium hydroxide.The word lye most accurately refers to sodium hydroxide (NaOH), [citation needed] but historically has been conflated to include other alkali materials, most notably potassium hydroxide (KOH).
The following chart shows the solubility of various ionic compounds in water at 1 atm pressure and room temperature (approx. 25 °C, 298.15 K). "Soluble" means the ionic compound doesn't precipitate, while "slightly soluble" and "insoluble" mean that a solid will precipitate; "slightly soluble" compounds like calcium sulfate may require heat to precipitate.