Ads
related to: cup seals for pneumatic cylinders
Search results
Results From The WOW.Com Content Network
Ensures that fluid does not leak from the cylinder and adequate pressure is maintained. [5] Wiper seal: Is installed on the outside of the cylinder. Its main function is to prevent dirt, debris, and other contaminants from entering the hydraulic system. Other types of dynamic seals include chevron seals, U-cup seals, and labyrinth seals.
Air cylinders are available in a variety of sizes and can typically range from a small 2.5 mm (1 ⁄ 10 in) air cylinder, which might be used for picking up a small transistor or other electronic component, to 400 mm (16 in) diameter air cylinders which would impart enough force to lift a car. Some pneumatic cylinders reach 1,000 mm (39 in) in ...
Inside the self-sealing suction cup, the plug is positioned close to the tube opening so that it can get sucked into the tube seal the hole when the central suction line is powered. A pair of springs connected to the suction cup's base helps maintain the plug's position, restoring the plug seal in the absence of object forces.
A centrally located and electrically-powered compressor powers cylinders, air motors, pneumatic actuators, and other pneumatic devices. A pneumatic system controlled through manual or automatic solenoid valves is selected when it provides a lower cost, more flexible, or safer alternative to electric motors, and hydraulic actuators.
The pin index safety system uses a face seal between the cylinder valve and the associated yoke clamp. There are two holes in specific positions on the cylinder valve body below the outlet port , in positions associated with the gas mixture, which prevent connection of the cylinder to a yoke or pressure regulator with a mis-matched set of pins.
A seal is a device or material that helps join systems, mechanisms or other materials together by preventing leakage (e.g. in a pumping system), containing pressure, or excluding contamination. The effectiveness of a seal is dependent on adhesion in the case of sealants and compression in the case of gaskets .