Search results
Results From The WOW.Com Content Network
The Arduino Uno is an open-source microcontroller board based on the Microchip ATmega328P microcontroller (MCU) and developed by Arduino.cc and initially released in 2010. [2] [3] The microcontroller board is equipped with sets of digital and analog input/output (I/O) pins that may be interfaced to various expansion boards (shields) and other circuits. [1]
Arduino Uno compatible, D13 pin isolated with a MOSFET of which can also be used as an input. KitTen [126] ATmega328P Freetronics Includes both 3.3 V and 5 V regulators for shields, D13 pin isolated with a MOSFET of which can also be used as an input. Can be connect to Arduino using CAT5 cable. [127] EtherDue [128] ATSAM3X8E [16] Freetronics
Arduino Mega compatible board with 16 extra I/O pins and the same a board size as the Arduino Uno. As with the Arduino Mega, most shields that were designed for the Duemilanove, Diecimila, or Uno will fit, but a few shields will not fit because of interference with the extra pins. Sippino [191] SpikenzieLabs
The default bootloader of the Arduino Uno is the Optiboot bootloader. [33] Boards are loaded with program code via a serial connection to another computer. Some serial Arduino boards contain a level shifter circuit to convert between RS-232 logic levels and transistor–transistor logic level signals.
The Arduino software includes a serial monitor which allows simple textual data to be sent to and from the Arduino board. The RX and TX LEDs on the board flash when data is being transmitted via the FTDI chip and the USB connection to the computer (but not for serial communication on pins 0 and 1).
ATmega328 is commonly used in many projects and autonomous systems where a simple, low-powered, low-cost micro-controller is needed. Perhaps the most common implementation of this chip is on the popular Arduino development platform, namely the Arduino Uno, Arduino Pro Mini [4] and Arduino Nano models.
The Make Controller Kit with an Atmel AT91SAM7X256 microcontroller.. A single-board microcontroller is a microcontroller built onto a single printed circuit board.This board provides all of the circuitry necessary for a useful control task: a microprocessor, I/O circuits, a clock generator, RAM, stored program memory and any necessary support ICs.
The JTAGICE mkII connects using USB, but there is an alternate connection via a serial port, which requires using a separate power supply. In addition to JTAG, the mkII supports ISP programming (using 6-pin or 10-pin adapters). Both the USB and serial links use a variant of the STK500 protocol.