Ads
related to: 1997 jeep wrangler 4 cylinder vs 6 cylinder
Search results
Results From The WOW.Com Content Network
The 4.0L "Power-Tech" Inline Six-Cylinder (I6) engine became standard equipment on all Wrangler TJ models, as the 2.4L "Power-Tech" Inline Four-Cylinder (I4) gas engine was dropped, and all Wrangler TJ models now featured the Chrysler NSG370 transmission (manual transmission) as standard equipment, as the five-speed manual transmission was ...
From 1997 until 2002, it was marketed as the "PowerTech I4." [7] It was produced through 2002 for the Jeep Wrangler, as well as for the Dodge Dakota pickup that also featured the AMC/Jeep-designed four-cylinder as its standard engine on regular-cab, rear-wheel-drive models from 1996 through 2002. [8]
The 282, which had a larger bore, is considered the ancestor of the L stroker engine, where it is common for the engine rebuilder to use an AMC 258 crankshaft in a Jeep 4.0 cylinder block – a 4.5 uses the stock AMC 258 connecting rods (with stock or .020 overbore using aftermarket pistons).
Introduced in 1996 as a 1997 model, the second-generation Wrangler reintroduced the round headlamps from the classic Jeep models. The main engine was the AMC 242 4.0 L inline 6. From the Wrangler TJ onwards, all Wranglers were fitted with coil-spring instead of leaf-spring suspension, the automatic shifter was relocated to the floor.
The "GEN-3" engines were available in Jeep utility vehicles starting in 1971. [3] It is not the same as Chrysler's 360 V8. [4] Chrysler continued production of the AMC 360 engine after the 1987 buyout of AMC to power the full-size Jeep Wagoneer (SJ) SUV that was produced until 1991. [5]
1.5 L (1,493 cc or 91.1 cu in) I3, with a single overhead camshaft, four valves-per-cylinder, and common-rail direct fuel injection. This engine was designed in 1998 with the related 4-cylinder variant R 420 SOHC. In 1999, VM granted Hyundai the license to manufacture both engines.
29-tooth input gear, 1 + 1 ⁄ 4 in (32 mm) intermediate shaft and 2.46:1 low range, 4 in (100 mm) input hole, Dana 20 case; The normal (3") input Dana 18s are interchangeable, but the input gear must match the transfer case. The "big hole" (4" input) Dana 18 is transmission-interchangeable with the Dana 20.
They were later also used in some rear wheel drive cars like the Jeep Wrangler. The engines were produced in two major variants differing by their piston displacement: a 3.3 L; 201.4 cu in (3,301 cc) and a 3.8 L; 230.5 cu in (3,778 cc). The 3.3 was dropped after 2010 with the Chrysler minivans, and the 3.8 was dropped after 2011 with the Jeep ...