Search results
Results From The WOW.Com Content Network
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
A PCB milling system is similar to a miniature and highly accurate NC milling table. For machine control, positioning information and machine control commands are sent from the controlling software via a serial port or parallel port connection to the milling machine's on-board controller. The controller is then responsible for driving and ...
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
A 2.5D machine, also called a two-and-a-half-axis mill, possesses the capability to translate in all three axes but can perform the cutting operation only in two of the three axes at a time due to hardware or software limitations, or a machine that has a solenoid instead of a true, linear Z axis. A typical example involves an XY table that ...
The original class of machine tools for milling was the milling machine (often called a mill). After the advent of computer numerical control (CNC) in the 1960s, milling machines evolved into machining centers : milling machines augmented by automatic tool changers, tool magazines or carousels, CNC capability, coolant systems, and enclosures.
Drafting pantograph in use Pantograph used for scaling a picture. The red shape is traced and enlarged. Pantograph 3d rendering. A pantograph (from Greek παντ- 'all, every' and γραφ- 'to write', from their original use for copying writing) is a mechanical linkage connected in a manner based on parallelograms so that the movement of one pen, in tracing an image, produces identical ...
Arbor milling is commonly performed on a horizontal milling machine. The tool is mounted on an arbor/mandrel (like an axle) that is suspended between the spindle and arbor support. This type of machine allows the tool to be placed in numerous positions in relation to the workpiece.
Intermediate rolls positioning Sketch 10 is of a 6 high mill showing the position of the intermediate rolls. In the 6 high mill shown in sketch 10, the roll between the work roll and the corresponding back-up roll is called an intermediate roll. These intermediate rolls have the ability to move horizontally slightly into or out of the mill stand.