Search results
Results From The WOW.Com Content Network
1 inch per second is equivalent to: = 0.0254 metres per second (exactly) = 1 ⁄ 12 or 0.08 3 feet per second (exactly) = 5 ⁄ 88 or 0.056 81 miles per hour (exactly) = 0.09144 km·h −1 (exactly) 1 metre per second ≈ 39.370079 inches per second (approximately) 1 foot per second = 12 inches per second (exactly)
A force capable of giving a mass of one kilogram an acceleration of one metre per second per second. [32] = 1 N = 1 kg⋅m/s 2: ounce-force: ozf ≡ g 0 × 1 oz = 0.278 013 850 953 781 25 N: pound-force: lbf: ≡ g 0 × 1 lb = 4.448 221 615 2605 N: poundal: pdl ≡ 1 lb⋅ft/s 2 = 0.138 254 954 376 N: short ton-force: tnf [citation needed] ≡ ...
Typical resolution is 500 mickeys per inch (16 mickeys per mm), but resolutions up to 16,000 mickeys per inch (600 mickeys per mm) are available. Muggeseggele A Muggeseggele is a humorous Alemannic German idiom used in Swabia to designate a nonspecific very small length or amount of something; it refers to a housefly 's scrotum .
Units are represented in UCUM with reference to a set of seven base units. [5] The UCUM base units are the metre for measurement of length, the second for time, the gram for mass, the coulomb for charge, the kelvin for temperature, the candela for luminous intensity, and the radian for plane angle.
move to sidebar hide. From Wikipedia, the free encyclopedia
Metric units are units based on the metre, gram or second and decimal (power of ten) multiples or sub-multiples of these. According to Schadow and McDonald, [1] metric units, in general, are those units "defined 'in the spirit' of the metric system, that emerged in late 18th century France and was rapidly adopted by scientists and engineers.
A new study says the ability to balance on one leg for at least 10 seconds means you could outlive most of your peers. That is, if you’re over the age of 50.
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...