When.com Web Search

  1. Ads

    related to: centimeters to fraction inches formula worksheet free printable

Search results

  1. Results From The WOW.Com Content Network
  2. Organ flue pipe scaling - Wikipedia

    en.wikipedia.org/wiki/Organ_flue_pipe_scaling

    Relationship between number of feet, octave and size of an open flue pipe (1′ = 1 foot = about 32 cm) Play ⓘ Scaling is the ratio of an organ pipe's diameter to its length. The scaling of a pipe is a major influence on its timbre. Reed pipes are scaled according to different formulas than for flue pipes.

  3. Conversion of units - Wikipedia

    en.wikipedia.org/wiki/Conversion_of_units

    The factor–label method is the sequential application of conversion factors expressed as fractions and arranged so that any dimensional unit appearing in both the numerator and denominator of any of the fractions can be cancelled out until only the desired set of dimensional units is obtained.

  4. Inch - Wikipedia

    en.wikipedia.org/wiki/Inch

    Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as ⁠2 + 3 / 8 ⁠ ″ and not as 2.375″ nor as ⁠2 + 6 / 16 ⁠ ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...

  5. Unit of measurement - Wikipedia

    en.wikipedia.org/wiki/Unit_of_measurement

    One way to make large numbers or small fractions easier to read, is to use unit prefixes. At some point in time though, the need to relate the two units might arise, and consequently the need to choose one unit as defining the other or vice versa. For example, an inch could be defined in terms of a barleycorn. A system of measurement is a ...

  6. Image sensor format - Wikipedia

    en.wikipedia.org/wiki/Image_sensor_format

    Sizes are often expressed as a fraction of an inch, with a one in the numerator, and a decimal number in the denominator. For example, 1/2.5 converts to 2/5 as a simple fraction, or 0.4 as a decimal number. This "inch" system gives a result approximately 1.5 times the length of the diagonal of the sensor.

  7. Drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).