Ads
related to: 12 inches ruler online free pdf
Search results
Results From The WOW.Com Content Network
The second, outer, cylinder is printed with the slide rule's primary logarithmic scale in the form of a 50-turn helix 12.70 metres; 500 inches (41 ft 8 in) long with annotations on the scale going from 100 to 1000. A brass tube with a mahogany cap at the top is a slide fit into the first cylinder.
A variety of rulers A carpenter's rule Retractable flexible rule or tape measure A closeup of a steel ruler A ruler in combination with a letter scale. A ruler, sometimes called a rule, scale or a line gauge or metre/meter stick, is an instrument used to make length measurements, whereby a length is read from a series of markings called "rules" along an edge of the device. [1]
[12] In 1871, Justus Roe introduced a cost cutting technique to the tape measure. [14] Employing rivets to attach small brass washers to the tape, he could mark inches and feet. To further enhance readability, small brass tags were affixed at five-foot intervals, each bearing a number indicating the total number of feet to that point. [15]
The pica is a typographic unit of measure corresponding to approximately 1 ⁄ 6 of an inch, or from 1 ⁄ 68 to 1 ⁄ 73 of a foot. One pica is further divided into 12 points. In printing, three pica measures are used: The French pica of 12 Didot points (also called cicero) generally is: 12 × 0.376 = 4.512 mm (0.1776 in).
The Fournier scale: two inches in total, divided into four half-inches, the medium intervals are one line (1 ⁄ 12 inch), and the smallest intervals are 1 ⁄ 36 inch; no intervals for the point is given, though. Fournier printed a reference scale of 144 points over two inches; however, it was too rough to accurately measure a single point. [11]
Subdivisions of an inch are typically written using dyadic fractions with odd number numerators; for example, two and three-eighths of an inch would be written as 2 + 3 / 8 ″ and not as 2.375″ nor as 2 + 6 / 16 ″. However, for engineering purposes fractions are commonly given to three or four places of decimals and have been ...
A scale ruler is a tool for measuring lengths and transferring measurements at a fixed ratio of length; two common examples are an architect's scale and engineer's scale.In scientific and engineering terminology, a device to measure linear distance and create proportional linear measurements is called a scale.
Linie – Line, usually 1 ⁄ 12 inch, but also 1 ⁄ 10. Zoll – Inch, usually 1 ⁄ 12 foot, but also 1 ⁄ 10. Fuss – Foot, varied between 23.51 cm in Wesel and 40.83 cm in Trier. Rheinfuss – Rhine foot, used in the North, 31.387 cm; Elle – Ell / cubit, distance between elbow and finger tip.