Search results
Results From The WOW.Com Content Network
Underdrive pulleys increase engine output by reducing the draw of the engine's accessories by slowing them down and reducing the horsepower (HP) they use. Horsepower gains from underdrive pulleys can vary by vehicle, engine, number of accessories and the amount of underdrive (improvements of up to 5–15 HP at the wheels have been seen).
A sheave or pulley wheel is a pulley using an axle supported by a frame or shell (block) to guide a cable or exert force. A pulley may have a groove or grooves between flanges around its circumference to locate the cable or belt. The drive element of a pulley system can be a rope, cable, belt, or chain.
The most common type of CVT uses a V-belt which runs between two variable-diameter pulleys. [2] The pulleys consist of two cone-shaped halves that move together and apart. The V-belt runs between these two halves, so the effective diameter of the pulley is dependent on the distance between the two halves of the pull
Serpentine belt (foreground) and dual vee belt (background) on a bus engine Belt tensioner providing pressure against the back of a serpentine belt in an automobile engine. A serpentine belt (or drive belt [1]) is a single, continuous belt used to drive multiple peripheral devices in an automotive engine, such as an alternator, power steering pump, water pump, air conditioning compressor, air ...
Belts are looped over pulleys and may have a twist between the pulleys, and the shafts need not be parallel. In a two pulley system, the belt can either drive the pulleys normally in one direction (the same if on parallel shafts), or the belt may be crossed, so that the direction of the driven shaft is reversed (the opposite direction to the ...
A dumb pulley can lift very large masses a short distance. It consists of two fixed pulleys of unequal radii that are attached to each other and rotate together, a single pulley bearing the load, and an endless rope looped around the pulleys. To avoid slippage, the rope is usually replaced by a chain, and the connected pulleys by sprockets.
Michael Pulley reflects on childhood sources of shame — an uninspiring family car, goofy hats and glasses — and how his views have changed. Michael Pulley: Dumpy cars, politicians and other ...
In a belt drive system, idlers are often used to alter the path of the belt, where a direct path would be impractical.. Idler pulleys are also often used to press against the back of a pulley in order to increase the wrap angle (and thus contact area) of a belt against the working pulleys, increasing the force-transfer capacity.