Ad
related to: online microphone test with playback speed and frequency changer pc
Search results
Results From The WOW.Com Content Network
The simplest way to change the duration or pitch of an audio recording is to change the playback speed. For a digital audio recording, this can be accomplished through sample rate conversion. When using this method, the frequencies in the recording are always scaled at the same ratio as the speed, transposing its perceived pitch up or down in ...
Older digital processors could often shift pitch only in post-production, whereas many modern devices using computer processing technology can change pitch values virtually in real time. [ 4 ] Pitch correction is a form of pitch shifting and is found in software such as Auto-Tune and Melodyne to correct intonation inaccuracies in a recording or ...
The latter term "vari-speed" is more commonly used for tape decks, particularly in the UK. Analog pitch controls vary the voltage being used by the playback device; digital controls use digital signal processing to change the playback speed or pitch. A typical DJ deck allows the pitch to be increased or reduced by up to 8%, which is achieved by ...
The measure of the low frequency (many tens of Hz) noise contributed by the turntable of an analogue playback system. It is caused by imperfect bearings, uneven motor windings, vibrations in driving bands in some turntables, room vibrations (e.g., from traffic) that is transmitted by the turntable mounting and so to the phono cartridge.
In order to take a scientific measurement with a microphone, its precise sensitivity must be known (in volts per pascal). Since this may change over the lifetime of the device, it is necessary to regularly calibrate measurement microphones. This service is offered by some microphone manufacturers and by independent testing laboratories.
It is a type of altered auditory feedback that—along with frequency-altered feedback and white noise masking—is used to treat stuttering; it has also demonstrated interesting discoveries about the auditory feedback system when used with non-stuttering individuals. It is most effective when used in both ears.
During playback, the pilot head functions as a push-pull playback head, facilitating the reproduction of the pilot tone. The playback mechanism compares the reproduced pilot signal to the line frequency (60/50 Hz), which governs the motor speed of the synchronous 16/35mm magnetic recorder and subsequently adjusts the playback speed accordingly.
Recommended dither for 16-bit digital audio measured using ITU-R 468 noise weighting is about 66 dB below alignment level, or 84 dB below digital full scale, which is comparable to the microphone and room noise level, and hence of little consequence in 16-bit audio.