Ads
related to: walmart under cabinet fluorescent light not working ballast
Search results
Results From The WOW.Com Content Network
[1] [3] To prevent this, fluorescent tubes are connected to the power line through a ballast. The ballast adds positive impedance (AC resistance) to the circuit to counteract the negative resistance of the tube, limiting the current. [1] Several American magnetic ballasts for fluorescent lamps. The top is a rapid start series autoregulator ...
Puck lights are round or oval and are good for cabinet and display lighting. Puck lights can create scallops, spots, or pools of lighting instead of even illumination across the counter top. Linear lights can come as a light strip or as a linear fixture or light bar. Linear fixtures resemble small puck lights on one mounting strip.
A preheat fluorescent lamp circuit using automatic starting switch. A: Fluorescent tube, B: Power (+220 volts), C: Starter, D: Switch (bi-metallic thermostat), E: Capacitor, F: Filaments, G: Ballast. When power is first applied to the circuit, there will be a glow discharge across the electrodes in the starter lamp.
Ballast: A ballast is an auxiliary piece of equipment designed to start and properly control the flow of power to discharge light sources such as fluorescent and high intensity discharge (HID) lamps. Some lamps require the ballast to have thermal protection.
A fluorescent lamp, or fluorescent tube, is a low-pressure mercury-vapor gas-discharge lamp that uses fluorescence to produce visible light. An electric current in the gas excites mercury vapor, to produce ultraviolet and make a phosphor coating in the lamp glow.
The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...
The energy-saving T12 lamps are made to operate on ballasts designed for 40-watt F40T12 lamps, though some F40T12 ballasts are not be designed to operate these lamps, and can overheat if energy-saving lamps are used. Running an energy-saving T8 tube with a ballast for T12 will reduce lamp life and can increase energy consumption. [9]
New lighting systems have not used magnetic ballasts since the turn of the century, however some older installations still remain. Fluorescent lamps with magnetic ballasts flicker at a normally unnoticeable frequency of 100 or 120 Hz (twice of the utility frequency; the lamp is lit on both the positive and negative half-wave of a cycle).