When.com Web Search

  1. Ads

    related to: welding oxygen tank

Search results

  1. Results From The WOW.Com Content Network
  2. Oxy-fuel welding and cutting - Wikipedia

    en.wikipedia.org/wiki/Oxy-fuel_welding_and_cutting

    An oxygen tank is especially dangerous because the gas is stored at a pressure of 21 MPa (3,000 psi; 210 atm)) when full. If the tank falls over and damages the valve, the tank can be jettisoned by the compressed oxygen escaping the cylinder at high speed. Tanks in this state are capable of breaking through a brick wall. [19]

  3. MAPP gas - Wikipedia

    en.wikipedia.org/wiki/MAPP_gas

    A set of MAPP and oxygen cylinders is used for oxy-fuel welding and cutting.. MAPP gas was a trademarked name, belonging to The Linde Group, a division of the former global chemical giant Union Carbide, for a fuel gas based on a stabilized mixture of methylacetylene (propyne), propadiene and propane.

  4. Weld purging - Wikipedia

    en.wikipedia.org/wiki/Weld_purging

    Some oxygen sensing instruments have the ability to give an alarm signal or close down the welding operation, when there is an unwanted rise in oxygen level. [17] Purging can continue until the oxygen level is low enough once more and welding can begin again. To avoid such situations, undesirable materials must be kept away from the weld zone.

  5. Oxygen storage - Wikipedia

    en.wikipedia.org/wiki/Oxygen_storage

    Oxygen tanks containing pressures of up to 200 bar (3000 psi) are used for industrial processes including the manufacturing of steel and monel, welding and cutting, medical breathing gas, diving and as an emergency breathing gas in aircraft. A small steel tank of 16 litres water capacity with a working pressure of 139 bar (2015 psi), holds ...

  6. Shielding gas - Wikipedia

    en.wikipedia.org/wiki/Shielding_gas

    Higher oxygen content allows higher speed of welding. More than 5% oxygen makes the shielding gas oxidize the electrode, which can lead to porosity in the deposit if the electrode does not contain sufficient deoxidizers. O-2 (98% argon/2% oxygen) is used for spray arc on stainless steel, carbon steels, and low alloy steels. Better wetting than O-1.

  7. List of welding processes - Wikipedia

    en.wikipedia.org/wiki/List_of_welding_processes

    Chemical welding process, not popular Limited Oxyacetylene welding: 311: OAW Combustion of acetylene with oxygen produces high-temperature flame, inexpensive equipment Maintenance, repair Oxygen/Propane welding 312: Gas welding with oxygen/propane flame Oxyhydrogen welding: 313: OHW Combustion of hydrogen with oxygen produces flame Limited