Search results
Results From The WOW.Com Content Network
The drag force can also be specified as where P D is the pressure exerted by the fluid on area A. Here the pressure P D is referred to as dynamic pressure due to the kinetic energy of the fluid experiencing relative flow velocity u .
Pressure (symbol: p or P) is the force applied perpendicular to the surface of an object per unit area over which that force is distributed. [ 1 ] : 445 Gauge pressure (also spelled gage pressure) [ a ] is the pressure relative to the ambient pressure.
Drag coefficients in fluids with Reynolds number approximately 10 4 [1] [2] Shapes are depicted with the same projected frontal area. In fluid dynamics, the drag coefficient (commonly denoted as: , or ) is a dimensionless quantity that is used to quantify the drag or resistance of an object in a fluid environment, such as air or water.
The coefficient of lift for a two-dimensional airfoil section with strictly horizontal surfaces can be calculated from the coefficient of pressure distribution by integration, or calculating the area between the lines on the distribution. This expression is not suitable for direct numeric integration using the panel method of lift approximation ...
The pound per square inch (abbreviation: psi) or, more accurately, pound-force per square inch (symbol: lbf/in 2), [1] is a unit of measurement of pressure or of stress based on avoirdupois units and used primarily in the United States. It is the pressure resulting from a force with magnitude of one pound-force applied to an area of one square ...
Bearing pressure is a particular case of contact mechanics often occurring in cases where a convex surface (male cylinder or sphere) contacts a concave surface (female cylinder or sphere: bore or hemispherical cup). Excessive contact pressure can lead to a typical bearing failure such as a plastic deformation similar to peening.
This additional pressure on the right piston will cause an upward force = = which is 50 times bigger than the force on the left piston. The difference between force and pressure is important: the additional pressure is exerted against the entire area of the larger piston. Since there is 50 times the area, 50 times as much force is exerted on ...
The formula to calculate average shear stress τ or force per unit area is: [1] =, where F is the force applied and A is the cross-sectional area.. The area involved corresponds to the material face parallel to the applied force vector, i.e., with surface normal vector perpendicular to the force.