Search results
Results From The WOW.Com Content Network
Volumetric flow rate should not be confused with volumetric flux, as defined by Darcy's law and represented by the symbol q, with units of m 3 /(m 2 ·s), that is, m·s −1. The integration of a flux over an area gives the volumetric flow rate. The SI unit is cubic metres per second (m 3 /s). Another unit used is standard cubic centimetres per ...
cubic foot per second ft 3 /s ≡ 1 ft 3 /s = 0.028 316 846 592 m 3 /s: cubic inch per minute in 3 /min ≡ 1 in 3 /min = 2.731 177 3 × 10 −7 m 3 /s cubic inch per second in 3 /s ≡ 1 in 3 /s = 1.638 7064 × 10 −5 m 3 /s: cubic metre per second (SI unit) m 3 /s ≡ 1 m 3 /s = 1 m 3 /s gallon (US fluid) per day GPD [citation needed] ≡ 1 ...
Cubic metre per second or cubic meter per second in American English (symbol m 3 ⋅ s −1 or m 3 /s) is the unit of volumetric flow rate in the International System of Units (SI). It corresponds to the exchange or movement of the volume of a cube with sides of one metre (39.37 in) in length (a cubic meter , originally a stere ) each second .
Because of the identity property of multiplication, multiplying any quantity (physical or not) by the dimensionless 1 does not change that quantity. [5] Once this and the conversion factor for seconds per hour have been multiplied by the original fraction to cancel out the units mile and hour, 10 miles per hour converts to 4.4704 metres per second.
References will be made to "actual" flow rate through a meter and "standard" or "base" flow rate through a meter with units such as acm/h (actual cubic meters per hour), sm 3 /sec (standard cubic meters per second), kscm/h (thousand standard cubic meters per hour), LFM (linear feet per minute), or MMSCFD (million standard cubic feet per day).
In oceanography, the sverdrup (symbol: Sv) is a non-SI metric unit of volumetric flow rate, with 1 Sv equal to 1 million cubic metres per second (264,172,052 US gal/s). [1] [2] It is equivalent to the SI derived unit cubic hectometer per second (symbol: hm 3 /s or hm 3 ⋅s −1): 1 Sv is equal to 1 hm 3 /s.
The average flow rate at the mouth of the Amazon is sufficient to fill more than 83 such pools each second. The estimated global total for all rivers is 1.2 × 10 6 m 3 /s (43 million cu ft/s), [ 1 ] of which the Amazon would be approximately 18%.
The rate of flow is typically expressed in units of cubic meters per second (m³/s) or cubic feet per second (cfs). Hydrographs often relate changes of precipitation to changes in discharge over time. [3] The term can also refer to a graph showing the volume of water reaching a particular outfall, or location in a sewerage network.