Ads
related to: electric plate cuttervevor.com has been visited by 100K+ users in the past month
- Automotive
Automotive Tools & equipments
Floor Jacks, diesel heater & more
- Restaurant & Food Service
High quality & 12-month warranty
Shop kitchen tools at honest prices
- Automotive
Search results
Results From The WOW.Com Content Network
Plasma cutting is an effective way of cutting thin and thick materials alike. Hand-held torches can usually cut up to 38 mm (1.5 in) thick steel plate, and stronger computer-controlled torches can cut steel up to 150 mm (6 in) thick.
2 Electrical discharge erosion (Electric arc). 3 Electrical potential. 4 Workpiece. In wire electrical discharge machining (WEDM), also known as wire-cut EDM and wire cutting, [30] a thin single-strand metal wire, usually brass, is fed through the workpiece, submerged in a tank of dielectric fluid, typically deionized water. [28]
A plasma torch (also known as a plasma arc, plasma gun, plasma cutter, or plasmatron) is a device for generating a directed flow of plasma. [ 1 ] [ 2 ] [ 3 ] The plasma jet can be used for applications including plasma cutting , plasma arc welding , plasma spraying , and plasma gasification for waste disposal.
Tests [citation needed] showed that an oxy-gasoline torch can cut steel plate up to 0.5 in (13 mm) thick at the same rate as oxy-acetylene. In plate thicknesses greater than 0.5 in (13 mm) the cutting rate was better than that of oxy-acetylene; at 4.5 in (110 mm) it was three times faster. [10]
Diagram of a laser cutter Laser cutting process on a sheet of steel CAD (top) and stainless steel laser-cut part (bottom) Laser cutting is a technology that uses a laser to vaporize materials, resulting in a cut edge. While typically used for industrial manufacturing applications, it is now used by schools, small businesses, architecture, and ...
The overall effect is a slower heating process, which causes tissue to coagulate. In simple coagulation/cutting mode machines, the lower duty cycle typical of coagulation mode is usually heard by the ear as a lower frequency and a rougher tone than the higher frequency tone typical of cutting mode with the same equipment.