When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. List of thread standards - Wikipedia

   en.wikipedia.org/wiki/List_of_thread_standards

   Metric Screw Threads: M Profile: V Thread Form ASME B1.15-1995 (R2003) Unified Inch Screw Threads (UNJ Thread Form) V Thread Form ASME B1.20.1-2013: Pipe Threads, General Purpose (Inch) Pipe Thread Form ANSI B1.20.3-1976 (R2013) Dryseal Pipe Threads (Inch) Pipe Thread Form ASME B1.20.7-1991 (R2013) Hose Coupling Screw Threads - Inch: Pipe ...

3. ISO 898 - Wikipedia

   en.wikipedia.org/wiki/ISO_898

   ISO 898 is an international standard that defines mechanical and physical properties for metric fasteners. This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1.

4. Lug nut - Wikipedia

   en.wikipedia.org/wiki/Lug_nut

   Additionally, under-tightened lug nuts may come loose with time. The tool size needed for removal and installation depends on the type of lug nut. The three most common hex sizes for lug nuts are 17 mm, 19 mm, and 21 mm, while 22 mm, 23 mm, 11 ⁄ 16 inch (17.5 mm), and 13 ⁄ 16 inch (20.6 mm) are less commonly used.

5. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Mechanical specifications of Metric/English sized nuts [5] Material Proof strength Min. tensile yield strength Min. tensile ultimate strength Nut marking Nut class ISO 898 (Metric) Low or medium carbon steel 380 MPa (55 ksi) 420 MPa (61 ksi) 520 MPa (75 ksi) 5 Medium carbon steel Q&T: 580 MPa (84 ksi) 640 MPa (93 ksi) 800 MPa (116 ksi) 8 Alloy ...

6. Unified Thread Standard - Wikipedia

   en.wikipedia.org/wiki/Unified_Thread_Standard

   The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

7. United States Standard thread - Wikipedia

   en.wikipedia.org/wiki/United_States_Standard_thread

   The metric standard used the same thread geometry as the USS standard but differed in that the dimensions and pitch were based on metric units. In 1906, the A.L.A.M developed what would be the SAE thread standard for threaded fasteners based on the USS standard but with a finer thread pitch. [6] [7]