When.com Web Search

  1. Ads

    related to: t5 vs t8 fluorescent tubes

Search results

  1. Results From The WOW.Com Content Network
  2. Fluorescent-lamp formats - Wikipedia

    en.wikipedia.org/wiki/Fluorescent-lamp_formats

    Running an energy-saving T8 tube with a ballast for T12 will reduce lamp life and can increase energy consumption. [9] Conversely, a T12 tube on a T8 ballast will usually draw too much power and so may burn out the ballast, unless it is within the range that particular ballast can compensate for.

  3. T5 retrofit conversion - Wikipedia

    en.wikipedia.org/wiki/T5_retrofit_conversion

    T5 retrofit conversion is a means of converting light fittings designed to use T8 format lamps, so that they can use more energy-efficient T5 lamps. [1] This is done by electronically converting the luminaires to high frequency operation.

  4. Fluorescent lamp - Wikipedia

    en.wikipedia.org/wiki/Fluorescent_lamp

    T12 fluorescent tubes. The first two are rapid start, (for "tombstone" and socket holders respectively) while the third is an instant-start lamp. The instant-start has a characteristic, rounded, single pin, for plugging into the spring-loaded socket holders. Instant start fluorescent tubes were invented in 1944. Instant start simply uses a high ...

  5. LED tube - Wikipedia

    en.wikipedia.org/wiki/LED_tube

    LED tubes. LED tube is a type of LED lamp used in fluorescent tube luminaires with G5 and G13 bases to replace traditional fluorescent tubes. [1] As compared to fluorescent tubes, the most important advantages of LED tubes are energy efficiency and long service life. LED tubes are sometimes also referred to as ‘LED fluorescent tubes’.

  6. Bi-pin lamp base - Wikipedia

    en.wikipedia.org/wiki/Bi-pin_lamp_base

    The suffix after the G indicates the pin spread; the G dates to the use of Glass for the original bulbs. GU usually also indicates that the lamp provides a mechanism for physical support by the luminaire: in some cases, each pin has a short section of larger diameter at the end (sometimes described as a "peg" rather than a "pin" [2]); the socket allows the bulb to lock into place by twisting ...

  7. Cove lighting - Wikipedia

    en.wikipedia.org/wiki/Cove_lighting

    Traditionally, cove lighting was installed by using T5 fluorescent tubes. T5 luminaires are an energy-efficient alternative to larger luminaires (such as T8 lamps) because they save on materials. [2] Lighting specialists recommend installing cove lighting at least 18 inches (46 cm) from the ceiling and 6 feet 8 inches (2.03 m) from the floor.