Ads
related to: aral pulse plug & charge meter digital multimeter instructions for dummies
Search results
Results From The WOW.Com Content Network
Aral AG (previously Veba Öl AG) is a German oil company established in 1898 as Westdeutsche Benzol-Verkaufs-Vereinigung GmbH (West German Benzene Marketing Corporation). The company is currently owned by British conglomerate BP [ 1 ] after it was purchased in 2002.
Analog multimeter Digital multimeter. A multimeter (also known as a volt-ohm-milliammeter, volt-ohmmeter or VOM) [1] is a measuring instrument that can measure multiple electrical properties. [2] [3] A typical multimeter can measure voltage, resistance, and current, [4] in which case can be used as a voltmeter, ohmmeter, and ammeter.
The alternating current signal produced by the flow of this charge is amplified and used as an analogue for the DC voltage applied to the capacitor. The DC input resistance of the electrometer is determined solely by the leakage resistance of the capacitor, and is typically extremely high, (although its AC input impedance is lower).
High-precision laboratory measurements of electrical quantities are used in experiments to determine fundamental physical properties such as the charge of the electron or the speed of light, and in the definition of the units for electrical measurements, with precision in some cases on the order of a few parts per million. Less precise ...
A digital clamp meter A multimeter with built-in clamp. Pushing the large button at the bottom opens the lower jaw of the clamp, allowing the clamp to be placed around a conductor. An electrical meter with integral AC current clamp is known as a clamp meter, clamp-on ammeter, tong tester, or colloquially as an amp clamp.
The Tweet-a-watt [13] is a hacked version of the standard Kill-A-Watt Plug in Power Meter. By piggybacking on the device's on-board LM2902N op-amp chip, the creator was able to get readings for voltage and current and transmit to a computer, which then sent this to Twitter via handle @tweetawatt. [ 14 ]
Pulse generators may use digital techniques, analog techniques, or a combination of both techniques to form the output pulses. For example, the pulse repetition rate and duration may be digitally controlled but the pulse amplitude and rise and fall times may be determined by analog circuitry in the output stage of the pulse generator.
In practice, an electrostatic charge monitoring probe is placed close (1 mm to 5 mm) to the surface to be measured, and the probe body is driven to the same potential as the measured unknown by an electronic circuit. This achieves a high-accuracy measurement that is virtually insensitive to variations in probe-to-surface distances.