Search results
Results From The WOW.Com Content Network
Honda FCX Concept 2005 in-wheel motor with high-voltage wires in orange. Running high voltage outside the chassis can be avoided by using near-wheel motors, which have similar advantages to in-wheel motors. Hub motors are attractive from a design standpoint because of their flexibility. They can be used for front-, rear-, or individual-wheel ...
To compensate for the uneven (35/65) weight distribution caused by the rear-mounted engine, DeLorean used rear wheels with a diameter slightly greater than the front wheels. Before that was the rear-engined Škoda's from Škoda 1000MB (produced from 1964) to Škoda 130/135/136 (produced until 1990) or the Polski Fiat 126p (produced until ...
Diagram of an epicyclic gearing system. An epicyclic differential uses epicyclic gearing to send certain proportions of torque to the front axle and the rear axle in an all-wheel drive vehicle. [citation needed] An advantage of the epicyclic design is its relatively compact width (when viewed along the axis of its input shaft). [citation needed]
A rear-engine, front-wheel-drive layout is one in which the engine is between or behind the rear wheels, and drives the front wheels via a driveshaft, the complete reverse of a conventional front-engine, rear-wheel-drive vehicle layout. This layout has only been used on prototype and concept cars.
In automobile design, a rear-engine design layout places the engine at the rear of the vehicle. The center of gravity of the engine itself is behind the rear axle. This is not to be confused with the center of gravity of the whole vehicle, as an imbalance of such proportions would make it impossible to keep the front wheels on the ground.
The J-2 engine also had a slightly thinner head gasket, raising compression to 10.0:1. It was advertised with gross power and torque ratings of 312 hp (233 kW) at 4600 rpm and 415 lb⋅ft (563 N⋅m) at 2800 rpm. Oldsmobile charged $83 for the J-2 option with the three-speed manual (or in the 98), [7] $314 with the automatic. [8]
The drivetrain design closest to RF in actual series production vehicles is the mid-engine, four-wheel-drive layout, typically seen in high end sportscar designs, and which, with the use of power-split centre differentials or hybrid drive systems, can be set up to send a variable amount of the total drive to the front wheels, in some cases up ...
The MG 350 comes with a 1.5 litre 4-cylinder engine producing 107 hp and 135 Nm of torque mated to a 4-speed automatic gearbox. [5] The MG 350 available in European markets is the first production car in the world with an Android operating System and 3G Internet access, [ 6 ] with engine options including a 1.5 liter turbo engine producing 129 ...